IBM ThinkPadT43

Recommendations

Info

wibmtpm /p wibmtpm aa.bin 4.Error in read and write data When you start the laptop the programmer must be disconnected. You can connect When you are prompted for the password, don't forget that (1)there are not any command line parameters(switches) (2)circuit not found or bus error If you disconnect the programmer and run the software you would be prompted with "circuit not found" but doesn't mean necessary that your circuit is healthy, not at all..... First:check the power,is the green LED shone? Second:Does the serial data line connect OK? Three: Your serial port is too weak. Check with other PC.
(3)eeprom is not available If you are prompted with "eeprom not found",it is a problem with the wires. Check them again (TPM1,TPM2 and GND) even that seems to be OK, you never know... Input command line parameters (switches) error,there is a space between the command line parameters. (4) Unknown eeprom dump,wrong file size! The size of file write to eeprom is error,it must be 1Kb. 5.test point for 43-Z60
Page 1 and 2: Manual for IBM T43-Z60 IBM notebook
Page 3: for example:ribmtpm aa.bin The file

IBM ThinkPadT43

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?