HX Series Remote Condenser Site Preparation and ... - Chiller City

Make sure the voltage of the power source agrees with the unit’s voltage andfrequency rating. The unit is designed to tolerate deviations of ±10% fromthe rated line voltage.A qualified electrician must make the electrical connections for both the baseunit and the remote condenser. A wiring diagram is provided to assist electricalinstallation. If additional information is necessary, contact our SalesDepartment.Wire the electrical connections in conformance with local, state, and federalcodes. Double check all wiring to make sure it is properly connected andprotected from the elements.RefrigerationRequirementsThe base unit is equipped with isolation valves and is shipped with a fullrefrigerant charge.The refrigeration lines that connect the base unit and the condenser, and thephysical connection of the two components are the customer's responsibility.Use the flow diagram below to assist plumbing installation. If further informationis necessary, contact our Sales Department.Do not operate ball valves, refrigerant escape and system contaminationwill result.7/8" ball valves installed in base unit by NESLAB.Schrader valves for evacuation, charging andrefrigerant recovery. Installed on base unit byNESLAB. Do not remove.7/8" flanged unions provided by NESLAB,customer installed.7/8" refrigeration ball valves providedby NESLAB, customer installed.Condenser relief valve pointin a safe direction.DISCHARGE LINELIQUID LINEBASE UNIT1/2" Compression fittingCONDENSER1/2" OD receiver relief vent line (customer provided andinstalled). Route outdoors and point in a safe direction.- 14 -