EUROSPOT - ADB Lighting Technologies

EUROSPOTGeneralitiesThis information is given in the best interest of safety,handling, installation, use and maintenance of theproduct. They must be read before any attempt ismade to use and/or install the product. Additionalcopies are available on request.• The luminaires must not be covered by heatinsulating material or by any other materialwhich prevents proper heat dissipation.• Observe carefully the limitation on theminimum distance between inflammablematerials and any part of the luminaire asindicated on the identification plate.• Luminaire enclosures should not be openedimmediately after switching off and adequatetime must be allowed for lamp to cool.• Do not operate luminaires without safety glassand /or lenses.• Replace all cracked or damaged safety glassesand/or lenses immediately.• For safety reasons, failed lamps should bereplaced promptly and the luminaire shouldbe switched off as soon as the lamp failure isnoted.• Unless otherwise stated, the luminaires aredesigned for direct connection to a standardmains supply as indicated on the identificationplate.• Inspection and cleaning should be carried outat regular intervals to ensure electrical andthermal safety as well as optical performanceof the luminaire.• Servicing, cleaning or lamp replacement shouldonly be carried out after the power supply cablehas been disconnected.• Repairs should be carried out only by suitablyqualified personnel. Only spare partsauthorised by ADB may be used.• ADB products must not be modified. Anymodification may render the product unsafe,and will invalidate any safety approval marks.ADB will not accept any liability for any damagecaused as a result of such a modification.Fitting PlugA suitable plug of at least 10/16A (220 V / 240V)rating should be fitted to the spotlight power cable,observing the connection colour code as follows :Brown or black - phaseBlue - neutralYellow, green -Earth/GroundImportant RemarkPower supply cables and other connections areessential for your equipment and contribute greatlyto a safe and trouble free operation.• Always hold the plug when disconnecting acable, never pull the cable.• Never use cables or connections in badcondition, check them before installation andperiodically thereafter.• Never tie power supply and data cablestogether.Remark: the weight of the accessories shall notbe more than 25% of the weight of the luminair.Inserting Shutter Blades• Place the lateral shutter blades near the lampand the vertical shutter blades near the lens.• Insert corner (A) between notches in shutterblade slot (C).• Push blade in until notch (B) engages in extremeedge of slot. This will allow clearance for corner(D) to be rotated fully into the housing.• Repeat in rotation until all shutter blades aresecurely home.P a g e 6Issue 001