stabilisierungsfinne stückliste einsatzbereich ... - Grabner Sports

ATTENTION: The sanded areas must becompletely free of dust and oil!►►Apply the glue thinly to the fitting andthe sanded area on the boat.►►Allow to dry 5-10 minutes until the gluesurface has dulled.►►Apply a second thin coat of glue.►►Allow to dry another 5-10 minutes.ATTENTION: Do not touch glue withhands!Reseal glue immediately after use!►►►►Glue the fitting onto the boat and pressvigorously.Remove any glue residue with GRAB-NER thinner (special accessories) andpress the fitting once again.ATTENTION: Thinner may not come intocontact with the glued areas - danger ofglue dissolving!►►Wait at least two hours before using theboat. Ideally the boat should rest, uninflated,overnight and weigh down with aheavy object.CAUTION►►Do not use the glue in direct sunlight!►►Ensure proper air circulation whenworking in enclosed areas!►►Keep out of reach of children!►►Do not use the glue near an open flame-FIRE HAZARD!Subject to change, technical changes errorsand missprints 10/11►►►►►►►►1.2.3.►►►►mounting the FinPump up the boat to their approximatefinished form.Put the fin with the long section from therear into the front fitting.Shift the fin again to the rear, so that youput the shorter section of the fin into therear fitting.Inflate your boat to the operational pressure.USAGE INSTRUCTIONSUse the stabilising fin only in sufficientlydeep waters where you do not contactthe groundDo not use the stabilising fin at whitewater►►Pay attention if you reach the waterside►►Not too strong side forces should cometo the stabilising fin.GRABNER GMBHWeistracherstraße 113350 HAAG, ÖsterreichTel: +43(0)7434/42251Fax: +43(0)7434/42251-66Mail: grabner@grabner-sports.atwww.grabner-sports.at