- Page 1:
LTV ® 1200 Ventilator / MR Conditi
- Page 4 and 5:
Warranty Pulmonetic Systems warrant
- Page 6 and 7:
Notice To Operators Unsafe Operatio
- Page 8 and 9:
Chapter 6 - Controls...............
- Page 10 and 11:
LPPS OFF...........................
- Page 12 and 13:
Chapter 15 - Troubleshooting ......
- Page 14 and 15:
Operator’s Safety Information All
- Page 16 and 17:
WARNING Battery run time - When the
- Page 18 and 19:
AVERTISSEMENT Personnel non qualifi
- Page 20 and 21:
AVERTISSEMENT Concentration d’oxy
- Page 22 and 23:
Cautions CAUTION Ventilator Sterili
- Page 24 and 25:
CAUTION External Battery Pack - The
- Page 26 and 27:
ATTENTION Nettoyage du panneau fron
- Page 28 and 29:
Symbols Symbol Compliance 3 Title A
- Page 30 and 31:
Indications for Use The LTV ® 1200
- Page 32 and 33:
Information/Assistance For addition
- Page 34 and 35:
Volume Control Breaths For Volume C
- Page 36 and 37:
Pressure Control Breaths (cont) Pre
- Page 38 and 39:
Spontaneous Breaths For Spontaneous
- Page 40 and 41:
SIMV Mode SIMV mode is selected whe
- Page 42 and 43:
NPPV Mode Non-invasive Positive Pre
- Page 44 and 45:
Volume Pressure Ventilation The LTV
- Page 46 and 47:
Setting a Control There are 5 kinds
- Page 48 and 49:
Bright, Dim and Blank Control Displ
- Page 50 and 51:
Control Locking The front panel con
- Page 52 and 53:
Breath Rate Use the Breath Rate con
- Page 54 and 55:
High Pressure Limit Use the High Pr
- Page 56 and 57:
Inspiratory Hold An Inspiratory Hol
- Page 58 and 59:
Expiratory Hold An Expiratory Hold
- Page 60 and 61:
Inspiratory Time This control sets
- Page 62 and 63:
Low Pressure The Low Pressure alarm
- Page 64 and 65:
Low Pressure O 2 Source (cont.) NOT
- Page 66 and 67:
Low Pressure O 2 Source (cont.) To
- Page 68 and 69:
O 2 % (O 2 Flush) The O2% (O2 Flush
- Page 70 and 71:
On/Standby This button switches the
- Page 72 and 73:
Pressure Control This control estab
- Page 74 and 75:
Select Use this button to change th
- Page 76 and 77:
Set Value Knob Use the Set Value kn
- Page 78 and 79:
Tidal Volume Use the Tidal Volume c
- Page 80 and 81:
Page 6-30 LTV ® 1200 Ventilator Op
- Page 82 and 83:
Battery Level The Battery Level ind
- Page 84 and 85:
Charge Status The Charge Status ind
- Page 86 and 87:
NPPV The NPPV 30 indicator LED is l
- Page 88 and 89:
Automatic or Manual Data Display Sc
- Page 90 and 91:
I:Ecalc xx:xx The Calculated I:E ra
- Page 92 and 93:
Alarms APNEA, APNEA xx bpm When the
- Page 94 and 95:
BAT EMPTY (cont.) NOTE When the bat
- Page 96 and 97:
BAT LOW (cont) NOTE Internal Batter
- Page 98 and 99:
DEFAULTS (cont.) The factory-set de
- Page 100 and 101:
DISC/SENSE When the ventilator dete
- Page 102 and 103:
HIGH O 2 PRES When the average oxyg
- Page 104 and 105:
HIGH PRES When the pressure in the
- Page 106 and 107:
HW FAULT When the ventilator detect
- Page 108 and 109:
LOW MIN VOL When the exhaled minute
- Page 110 and 111:
LOW PEEP When the patient circuit p
- Page 112 and 113:
NO CAL DATA, NO CAL Monitor Display
- Page 114 and 115:
POWER LOW When the ventilator is op
- Page 116 and 117:
RESET / RESET 1 A RESET or a RESET
- Page 118 and 119:
SBT > f When the Spontaneous Breath
- Page 120 and 121:
SBT > f/Vt When the Spontaneous Bre
- Page 122 and 123:
XDCR FAULT When a transducer autoze
- Page 124 and 125:
H&L PEEP OFF The H&L PEEP OFF messa
- Page 126 and 127:
LO f/Vt OFF The LO f/Vt OFF message
- Page 128 and 129:
SBT TIME The SBT TIME message is di
- Page 130 and 131:
Navigating the Extended Features Me
- Page 132 and 133: Apnea Interval Use this menu item t
- Page 134 and 135: Patient Assist Use the PNT ASSIST m
- Page 136 and 137: Variable Rise Time Use the Variable
- Page 138 and 139: Variable Time Termination Use the V
- Page 140 and 141: Leak Compensation Use the Leak Comp
- Page 142 and 143: O 2 Flush Use the O2 Flush option t
- Page 144 and 145: Software Version Use the Software V
- Page 146 and 147: Set Time Use the Set Time option to
- Page 148 and 149: Valve Home Position Use the Valve H
- Page 150 and 151: O 2 Cylinder Duration (cont.) 4) Tu
- Page 152 and 153: LTV ® 1200 Presets Table Feature/F
- Page 154 and 155: SBT Operations (cont.) When the Spo
- Page 156 and 157: Transducer Autozero Use the Transdu
- Page 158 and 159: Exhalation Flow Transducer Differen
- Page 160 and 161: Real Time Transducers Use the Real
- Page 162 and 163: Page 10-34 LTV ® 1200 Ventilator O
- Page 164 and 165: To enable the Ventilator Checkout m
- Page 166 and 167: Display Test Use the Display Test t
- Page 168 and 169: Control Test Use the Control Test t
- Page 170 and 171: Leak Test Use the Leak Test to test
- Page 172 and 173: Vent Inop Alarm Test Use the Vent I
- Page 174 and 175: Exit To exit the vent check mode an
- Page 176 and 177: To Turn the Ventilator On (cont.) I
- Page 178 and 179: Procedure for Control Mode Set Up S
- Page 180 and 181: Procedure for SIMV Mode Set Up Set
- Page 184 and 185: LTV ® Ventilator Settings Checklis
- Page 186 and 187: Cleaning or replacing the Fan Filte
- Page 188 and 189: Cleaning or Replacing the O 2 Inlet
- Page 190 and 191: Cleaning the Exhalation Valve and R
- Page 192 and 193: ATTENTION Nettoyage du piège à ea
- Page 194 and 195: To clean the exhalation valve, sens
- Page 196 and 197: Page 13-12 LTV ® 1200 Ventilator O
- Page 198 and 199: Using the AC Adapter To run the ven
- Page 200 and 201: 2) Connect the power connector on t
- Page 202 and 203: Using the Automobile Cigarette Ligh
- Page 204 and 205: CAUTION Release Button - To avoid d
- Page 206 and 207: Replacing the Automobile Adapter Fu
- Page 208 and 209: Caring for the Internal Battery The
- Page 210 and 211: Displays and Buttons Some of the sy
- Page 212 and 213: Symptoms Possible Causes What to Do
- Page 214 and 215: Ventilator Performance Symptoms Pos
- Page 216 and 217: Symptoms Possible Causes What to Do
- Page 218 and 219: Symptoms Possible Causes What to Do
- Page 220 and 221: Symptoms Possible Causes What to Do
- Page 222 and 223: Symptoms Possible Causes What to Do
- Page 224 and 225: Problem Possible Causes What To Do
- Page 226 and 227: Alarm Name Displayed Alarm Priority
- Page 228 and 229: Symptoms Possible Causes What to Do
- Page 230 and 231: Symptoms Possible Causes What to Do
- Page 232 and 233:
Symptoms Possible Causes What to Do
- Page 234 and 235:
Symptoms Possible Causes What to Do
- Page 236 and 237:
MR Conditional System - Conditions
- Page 238 and 239:
WARNING • Put the MR Conditional
- Page 240 and 241:
Control Range Tolerance PIP LED Dis
- Page 242 and 243:
Fixed Alarms Control Range Toleranc
- Page 244 and 245:
Displays Packaging Display Range To
- Page 246 and 247:
Power Feature Range Tolerance / Ind
- Page 248 and 249:
Page A-10 LTV ® 1200 Ventilator Op
- Page 250 and 251:
Service Assistance For assistance i
- Page 252 and 253:
Protective Boots Rubberized protect
- Page 254 and 255:
• Item (1), Protective Boot, Uppe
- Page 256 and 257:
Protective Boot Installation Suppli
- Page 258 and 259:
To Install the Lower Protective Boo
- Page 260 and 261:
Patient Breathing Circuit - Connect
- Page 262 and 263:
Oxygen Lines - Connection Instructi
- Page 264 and 265:
Patient Assist Call System - Connec
- Page 266 and 267:
Using the Remote Alarm Cable Use th
- Page 268 and 269:
Checking the Ventilator for Proper
- Page 270 and 271:
Ventilator Proper Operation Workshe
- Page 272 and 273:
Page C-22 LTV ® 1200 Ventilator Op
- Page 274 and 275:
Ventilation flow enters the Flow Va
- Page 276 and 277:
5) Push the Select button. • xx:e
- Page 278 and 279:
Code Event Name Event Associated Al
- Page 280 and 281:
Event Codes by Event Name Event Nam
- Page 282 and 283:
Event Name Code Event Associated Al
- Page 284 and 285:
TERM DEFINITION Control mode A vent
- Page 286 and 287:
TERM DEFINITION PIP Peak Inspirator
- Page 288 and 289:
Page F-6 LTV ® 1200 Ventilator Ope
- Page 290 and 291:
Button Controls · 5-3 C Calculated
- Page 292 and 293:
Mean Airway Pressure · 8-2, 8-3 Mi
- Page 294:
X XDCR FAULT · 9-32, 15-21 XDCR ZE