Installation & Instruction Manual - Standard Change

larger denomination dispenser is available. Remember – the Make Best Change will try to dispense from
the larger dispenser first.
The first step (7) will set the ten’s digit (of the two digit number), the second step (8) will be used to set
the second digit. The Forced Dispense amount can be from 0 to 99. Use the parameter table below to set
the TENS DIGIT as well as the ONES DIGIT for this feature.
Example: A nickel coin dispenser and a quarter coin dispenser are present. You would like to force at
least 5 nickels to be dispensed for every bill deposited. In the MBCM, the vend would consist of only
quarters. To change this you would set the nickel dispenser to be the Primary device and set the Forced
Dispense to 5. The dispense would then consist of the Forced Dispense amount or 5 nickels, and the rest
would be issued in quarters. Note – the forced dispense only forces from the Primary device.
Forced Dispense Override (Feature Type = Machine)
• Default Settings = OFF
This feature allows the machine to ignore the Forced Dispense Feature setting under special deposit
circumstances. The special circumstance occurs when the deposit is Equal To an available dispenser. If
the value of the amount deposited matches a dispenser value, a dispense is issued from that dispenser.
In this way the dispenser value overrides (ignores) the Forced Dispense Feature setting. Note: this
feature is rarely implemented as it typically not necessary to accommodate the desired vend responses.
Example: Feature Settings are set to: Primary Device (Dispenser)= $.05 (nickel hopper), Secondary
Device (Dispenser) = $1.00 ($1 coin hopper or bill dispenser), and Forced Dispense Feature setting =
20.
$1 accepted: Payout is 0 from the Primary Device and 1 from the Secondary Device.
Note: The forced Dispense Feature would normally force 20 nickels to be dispensed.
$5 accepted: Payout is 20 from the Primary Device and 4 from the Secondary Device.
Accumulate (Feature Type = Machine)
• Default Settings = Disabled
When this feature is enabled, a dispense will not occur until enough money has been accepted to meet or
exceed the value of the PRIMARY DEVICE. Make Best Change will then occur.
Dispenser Type (Feature Type = Device)
• Default Settings = Coin
This feature is only necessary if you wish to convert a dispenser from one type (say a regular coin –
quarter) to a token type (say a .984 token). Changing this feature can greatly alter how your machine
works. Valid dispenser types are: Coin, token, bill, ticket and card.
27