Installation & Instruction Manual - Standard Change
Installation & Instruction Manual - Standard Change
Installation & Instruction Manual - Standard Change
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Bill Dispenser Cleaning<br />
• Fujitsu F50 and F53 Bill Dispensers - The owner’s manual for these dispensers will identify<br />
the maintenance items associated with each specific model. If you did not receive the manual<br />
please contact the nearest <strong>Standard</strong> <strong>Change</strong>-Makers service center for a replacement manual.<br />
• Uninote Bill Dispenser - The feed, picker and conveyor rollers must be cleaned on a regular<br />
basis. It is required that these surface’s be cleaned at least every 5000 dispenses. The feed<br />
rollers can be cleaned by pressing a dampened wipe into the gap where this roller is visible<br />
while depressing the run button. This should be repeated two or three times on fresh areas of<br />
the alcohol wipe. The picker and conveyor rollers should be cleaned in a similar manner.<br />
The rollers can also be cleaned as described above by turning the motor pulley instead of<br />
using the run switch.<br />
CAUTION: USING CLEANING AGENTS THAT INCLUDE ALCOHOL MAY<br />
PERMANENTLY DAMAGE THE ROLLERS.<br />
IMPORTANT: When cleaning rollers with isopropyl alcohol wipes, use lightly. Do not<br />
soak the rollers. If rollers become soaked, do not run the unit. Allow rollers to dry<br />
completely. Immediate damage to the rollers will occur if the unit is run while the rollers<br />
are wet.<br />
CAUTION!<br />
Do not run the bill dispenser feed mechanism without bills for an extended period of time.<br />
Damage may result.<br />
MOTOR<br />
PULLEY<br />
FEED AND<br />
PICKER<br />
ROLLERS<br />
LOWER<br />
CONVEYOR<br />
ROLLERS<br />
37<br />
RUN<br />
SWITCH