eye showers

Eye showers
Sekuroka ® -eye showers
In compliance with DIN EN 15154-2:2006.
DVGW-certified.
• Rubber sleeves to protect against injury
• Dust caps open automatically when actuated
• Integral flow control ensures a steady jet of water
even if water pressure varies
• With extremely wide-stream shower head
for a large surface water distribution
• Large holes in the shower heads
protect against scaling
• Shower heads can be removed easily
for maintenance
• Self-adhesive information label in compliance
with DIN 4844-2D and BGV A8, 150 x 150 mm
Eye shower Model 1
With a vertical shower head.
With non-automatic closing valve for wall and vertical desk top
mounting. The release lever locks automatically, and the water can easily
be shut off by releasing the lever. Made of plastic (media-conveying parts
are made of brass). Silicone hose stainless steel clad, 1.5 m long.
Flow rate 7 l/min per shower head at a minimum operating pressure of 1 bar.
½″ connection, internal thread, union nut.
Art. No. Pack Qty. €
KT00.1 1 170,95
All laboratories must install an eye shower, which meets the requirements of
DIN EN15154-2 (Guidelines for Laboratories BGR 120, Point 6.6.2).
In the event of contamination or cauterization, both eyes can, therefore, be rinsed
immediately and for as long as necessary with a constant supply of drinking water.
Eye wash flasks, which do meet the requirements of DIN EN15154-4, can still be
used to supplement the emergency eye showers. Should eye wash flasks be used,
then preferably those with special rinsing solution.
390
GLOBAL STEP SRL /Tel/Fax: 031 104 85 87 / Tel: 0742 095 539 / office@global-step.net / www.global-step.net
Eye shower Model 2
Identical to model 1 except that the shower head is inclined at 45°,
allowing the eye bath to be used without removing it from the wall
or desktop holder.
With 1 shower head
Art. No. Pack Qty. €
KT01.1 1 213,95
With 2 shower heads
Art. No. Pack Qty. €
KT02.1 1 252,65
Eye shower Model 3
For table assembly. Two 45° offset shower heads and distributor fork made
of brass, with chemically resistant green powder coating. With large release
lever, 130 mm long and big "PUSH“ sign, luminescent according to
DIN 67510. Maintenance-free ball valve, 90° operation, made of stainless
steel, does not close automatically, DIN-DVGW certified and approved.
Flow rate 14-16 l/min at a minimum operating pressure of 1 bar.
Connection ½″ outer thread incl. attachment kit.
Dimensions: W (incl. lever) 240 x H 180 mm.
Art. No. Pack Qty. €
LP23.1 1 137,60