Programmer's Reference Manual Intermec Fingerprint® v8.70.0 ...

Chapter 7—Error Messages
Code Message/Explanation
1213 Speedo error six.
1214 Squeeze or clip not supported.
1215 Character data not available.
1216 Unknown font.
1217 Font format is not supported.
1218 Correct mapping table is not found.
1219 Font is in the wrong direction.
1220 Error in external map table.
1221 Map table was not found.
1222 Double byte map table is missing.
1223 Single byte map table is missing.
1224 Character map function is missing.
1225 Double byte font is not selected.
1301 Index outside collection bounds.
1302 Collection could not be expanded.
1303 Parameter is not a collection.
1304 Item not a member of the collection.
1305 No compare function, or compare
returns faulty
1306 Tried to insert a duplicate item.
1320 No RFID support installed.
1321 No tag found.
1322 Access outside tag memory.
1323 Tag format error.
1324 RFID inactive.
1325 Not supported tag type.
1601 Reference Font Not Found.
1602 Error in Wand-Device.
1603 Error in Slave Processor.
1604 Print Shift Error.
1605 No Hardware Lock.
1606 Testfeed not done.
1607 General Print Error.
1608 Access Denied.
1609 Specified Feed Length Exceeded.
1610 Illegal Character Map File.
1701 Cutter not back in position after cut.
1702 Cutter has not reached upper position:
unsuccessful cut.
1703 Cutter not back in position after unsuccessful
cut.
1704 Cutter open.
1710 Power supply Generic Error
1711 Power supply Pending
1712 Power supply Status OK
Code Message/Explanation
1713 Power supply Power Fail
1714 Power supply Over Volt V24
1715 Power supply Under Volt V24
1716 Power supply Over Volt VSTM
1717 Power supply Under Volt VSTM
1718 Power supply Over Temperature
1719 Power supply Error
1820 No route to host
1821 Disc quota exceeded
1833 Connection refused
0 Intermec Fingerprint v8.70.0/v10.0.0 Programmer´s Reference Manual