Dashboards and Widgets Creation Guide - MicroStrategy

4
Providing Interactivity to Users: Selectors Dashboards and Widgets Creation Guide
For example, a dashboard has automatic target maintenance enabled. The
dashboard contains the following objects:
• In the Document Header section:
Grid/Graph 1
Selector 1, which targets Grid/Graph 1 to display data about the
selected Region
• In the Detail Header section:
Grid/Graph 2
Panel Stack 1
Selector 2, which targets Grid/Graph 2, to display data about the
selected region, and Panel Stack 1, to display the selected region name
Panel Stack Selector, which targets Panel Stack 1 to switch panels
Disable automatic target maintenance. The selector targets remain the same,
but you can now modify them manually, as shown in the Properties dialog
box below:
Add another selector to the Detail Header section. No targets are
automatically defined, so you must manually define the targets.
To disable automatic target maintenance while editing a selector
This procedure assumes that you are editing the settings of a selector.
1 On the Selector tab of the Properties dialog box, click Manual Targets. A
warning message opens, indicating that you will need to manually
maintain targets if you disable automatic target maintenance.
2 Click OK. You are returned to the Properties dialog box. Automatic target
maintenance has been disabled for all selectors in the layout.
142 Automatically maintaining targets for selectors © 2012 MicroStrategy, Inc.