4 2 (B) (A) 7 1 5 3 11 7 Press the bobbin winding button again . When the bobbin is fully wound, the bobbin winder stopper returns to the original position and the machine will stop automatically. Cut the thread with the thread cutter. Inserting the Bobbin 1 Place the bobbin in the bobbin holder with the thread running off counterclockwise. 2 Guide the thread into the front notch (A) on the bobbin holder. 3 Draw the thread to the left, sliding it between the tension spring blades. 4 Continue to draw the thread lightly until the thread slips into the side notch (B). 5 Pull out about 10 cm (4") of thread to the rear. Reattach the hook cover plate. NOTE: A threading chart is shown on the hook cover plate for your reference.
4 2 7 3 1 5 6 12 Threading the Machine Raise the presser foot. Press the needle up/down button twice to raise the needle. Turn the power switch off. 1 Draw the thread from the spool. Hold the thread with both hands and pass the thread under the thread guide plate. Tug the thread until it snaps. 2 Draw the thread down along the right channel and around the bottom of the guide plate. 3 Pull the thread up along the left channel to the thread take-up lever. 4 Firmly draw the thread up to the take-up lever and down into its eye from the right to the left, while holding the thread at the spool. 5 Then pull the thread down along the left channel and through the lower thread guide. 6 Slide the thread behind the needle bar thread guide on the left. 7 Thread the needle with the automatic needle threader (refer to the next page).