IMPORTANT SAFETY INSTRUCTIONS SAVE THESE ... - Janome

content.janome.com

IMPORTANT SAFETY INSTRUCTIONS SAVE THESE ... - Janome

1

2

3

4

(A)

5













(C)

Touch Screen Calibration

PRESS MARK (+).

Resume last pattern?

(B)

Format Memory?

All the stored data will be erased.

Built-in

inch/mm


Touch Screen Calibration

END

inch

X

mm

21

1 Resume Mode

When Resume Mode is enabled, the last pattern

sewn before turning the power off will be resumed

when the power is turned on again.

To enable Resume Mode, press the on/off key to

check the box on.

When you turn the power on, the confirmation

window will open.

Press the OK key to resume the last sewn pattern.

NOTE:

If you switch from the embroidery mode to the ordinary

sewing mode or vice versa before turning the power off,

Resume Mode will be disabled.

2 Touch screen calibration

If you think the touch panel keys are out of alignment,

you can correct it in the key position adjustment

window.

When you press the key, window (A) will be shown.

With your finger, press the black cross as it appears in

order. When you press the last black coss, the window

(B) will be shown. The window will close and go back to

the original screen with the new setting being

registered.

3 Formatting the memory

If the internal memory, ATA PC card or USB memory

key does not function due to damage to the memory

bank, you need to re-enable it by formatting the

memory.

4 Resetting all to default

Press the yes key to reset all the parameters to the

original values (factory settings).

5 Inch/mm options

You can set your machine's measuring unit to either

inch or millimeter by pressing the “inch” or “mm” key.

The default unit setting is millimeter.

More magazines by this user
Similar magazines