IMPORTANT SAFETY INSTRUCTIONS SAVE THESE ... - Janome

content.janome.com

IMPORTANT SAFETY INSTRUCTIONS SAVE THESE ... - Janome

Button Sewing

3.5

56

Button sewing

Use the button sewing foot T and reduce the foot

pressure.

When attaching a button to a thick fabric, you need to

make a shank by using the button shank plate.

The feed dog will automatically lowered when selecting

the button sewing section.

Attach the button sewing foot T (refer to page 17) and

set the foot pressure dial at “2”.

Place a button on a fabric and lower the needle into the

left hole in the button by turning the handwheel with

your hand.

Lower the foot to hold the button in place, aligning the

direction of the button.

Raise the needle by turning the handwheel until the

needle bar swings to the right.

Press the “+” or “–” key so the needle enters into the

right hole in the button.

Lower the needle into the fabric and push the button

shank plate into between the button and fabric.

Start the machine to sew until it stops automatically.

Remove the fabric from the machine.

Pull the needle thread at the end of stitching to bring the

bobbin thread up to the right side of the fabric.

Draw the both threads between the button and fabric.

Wind the threads to form a shank and knot them

together.

More magazines by this user
Similar magazines