IMPORTANT SAFETY INSTRUCTIONS SAVE THESE ... - Janome

content.janome.com

IMPORTANT SAFETY INSTRUCTIONS SAVE THESE ... - Janome

4

3

1 2

6 7

1 Start/stop button

Press this button to start or stop the machine. This button

can be used either in the ordinary sewing mode or

embroidery mode. In the ordinary sewing mode, the machine

starts running slowly for the first few stitches, it then runs at

the speed set by the speed control slider. The machine runs

slowly as long as this button is pressed.

The button will turn red when the machine is running, and

green, that it has been stopped.

NOTE:

The start/stop button cannot be used in the ordinary sewing

mode when the foot control is connected to the machine.

2 Reverse button

When sewing stitch pattern U1, U2, U8 or U9, the machine

will sew in reverse as long as the reverse button is pressed.

If the stitch pattern U1, U2, U8 or U9 has been selected and

the foot control is not connected, the machine will start

sewing in reverse as long as the reverse button is pressed.

If you press the reverse button when sewing any other

stitches, the machine will immediately sew locking stitches

and automatically stop.

3 Needle up/down button

Press this button to bring the needle bar up or down.

5

8

8

Machine Operating Buttons

4 Auto-lock button

When sewing stitch pattern U1, U2, U8 or U9, the

machine will immediately sew locking stitches and

automatically stop when the auto-lock button is

pressed.

When sewing all other stitches, the machine will sew

to the end of the current pattern, sew locking stitches

and stop automatically.

The machine will trim the threads automatically after

locking the stitch when the auto thread cutting is

enabled (refer to page 22).

5 Speed control slider

This slider will set the maximum sewing speed in the

ordinary sewing mode (refer to page 9).

6 Auto needle threader button

Press this button and follow the step-by-step

instruction displayed on the visual touch screen to

thread the needle.

Refer to page 13.

7 Bobbin winding button

Press this button to wind the bobbin.

Refer to page 10.

8 Thread cutter button

Press this button after finishing sewing and the

machine will trim the threads automatically.

Refer to page 27.

NOTES:

The thread cutter button does not function:

- soon after turning on the power.

- when the presser foot is in the up position.

- when being pressed 4 times in a row.

More magazines by this user
Similar magazines