Operator Terminal System Manual - 11276916.pdf
Operator Terminal System Manual - 11276916.pdf
Operator Terminal System Manual - 11276916.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Network Functions and Communication<br />
9 Communication<br />
Connecting three<br />
terminals in passthrough<br />
mode<br />
Pass-through<br />
mode<br />
<strong>Terminal</strong> and PC<br />
settings<br />
Access time to the controller<br />
<strong>Terminal</strong>s <strong>Terminal</strong> 1 <strong>Terminal</strong> 2 <strong>Terminal</strong> 3 <strong>Terminal</strong> 4<br />
1 100 % – – –<br />
2 50 % 50 % – –<br />
3 50 % 25 % 25 % –<br />
4 50 % 25 % 12,5 % 12,5 %<br />
You can connect a third terminal to terminal two in the network using a cable. Setup is<br />
the same as for the second terminal.<br />
The [pass-through mode] function allows for setting the terminal in such a way that<br />
communication can take place between the PC programming software (in this case<br />
MOVITOOLS ® ) for the connected controller and the controller itself (MOVIDRIVE ® or<br />
MOVITRAC ® 07) via operator terminal.<br />
The function is analog to the transparent mode function and also only supports one<br />
controller. Consequently, transparent or pass-through mode can only be performed on<br />
one communication port of the terminal.<br />
If pass-through mode is active and the PC communicates with the controller via terminal,<br />
the communication between terminal and connected controller will be interrupted. This<br />
is the difference between pass-through mode and transparent mode. A terminal on<br />
which a communication in pass-through mode takes place will be locked for the operator<br />
and only show an empty screen with a reference made to the pass-through mode.<br />
Pass-through mode for one of the connected controllers is activated or deactivated via<br />
the [DOP Tools] / [DOP Connect] program. You find the program as icon in the [DOP<br />
Tools] program group.<br />
DOP11A-10 does NOT support pass-through mode with DOP Connect.<br />
The MOVILINK ® driver for MOVIDRIVE ® and MOVITRAC ® 07 units only supports passthrough<br />
mode. Transparent mode is not supported.<br />
The following PC and terminal settings are required to enable pass-through mode:<br />
Make the communication setting in the terminal project in HMI-Builder under [Setup] /<br />
[Peripherals]. Drag the [Transparent mode] element to the required communication port<br />
(i.e. the port to which the PC is connected with the terminal).<br />
To configure pass-through mode, right-click the element. The settings for the port to<br />
which the PC is connected must be identical with the settings in the PC program (programming<br />
software for the controller).<br />
224 <strong>System</strong> <strong>Manual</strong> – DOP11A <strong>Operator</strong> <strong>Terminal</strong>s
Change language