Operator Terminal System Manual - 11276916.pdf

I
Programming
7 Communication with MOVIDRIVE® and MOVITRAC® 07
0
Communication settings in the HMI-Builder
Setup of communication between operator terminal and inverter
The settings for communication between operator terminal and inverter are made in the
HMI-Builder under [Setup] / [Peripherals].
Figure 28: Communication settings
10771AEN
To change the communication port, select [Controller 1] (or [Controller 2]), hold the left
mouse button pressed and drag the controller to the other communication port.
To enter the communication parameter, press the right mouse button.
60 System Manual – DOP11A Operator Terminals