Operator Terminal System Manual - 11276916.pdf

Default settings
System Manual – DOP11A Operator Terminals
Programming
Communication with MOVIDRIVE® and MOVITRAC® 07
Figure 29: Default settings
Port RS-232C or RS-422
Baud rate 9600
Data bits 8
Stop bits 1
Parity Even
Settings The RS-485 inverter address is defined under Settings.
You can enter values between 0-99, 254 and 255.
10772AXX
Parameter Description
Default station A communication is established with the inverter address entered under Default station
during startup of the operator terminal after power on.
This inverter address will always be used if no other RS-485 address is specified when
defining the communication objects.
Address Use / description
0-99 Individual inverter address
254 Peer-to-peer communicaton
This address must not be used when several inverters are connected with the operator
terminal via RS-485.
255 Broadcast address
All inverters connected to the RS-485 bus receive data but do not return a response to
the operator terminal.
I
0
7
61