Operator Terminal System Manual - 11276916.pdf
Operator Terminal System Manual - 11276916.pdf
Operator Terminal System Manual - 11276916.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2 Safety Notes<br />
General<br />
information<br />
Installation and<br />
startup<br />
<strong>System</strong> <strong>Manual</strong> – DOP11A <strong>Operator</strong> <strong>Terminal</strong>s<br />
Safety Notes<br />
Read the safety precautions carefully.<br />
Check the delivery for transport damage. If damage is found, advise your supplier.<br />
The terminal fulfills the requirements of article 4 of EMC directive 89/336/EEC.<br />
Do not use the terminal in an envi ronment with high explosive hazard.<br />
SEW-EURODRIVE is not liable for modi fications, changes, additions and / or<br />
alterations to the product.<br />
Use only spare parts and accessor ies manufactured according to SEW-<br />
EURODRIVE specifications.<br />
Read the installation and operating instruct ions completely and carefully prior to<br />
installation, use or repair of the terminal.<br />
Never allow fluids to penetrate the slots or holes in the terminal. This may lead to a<br />
fire or cause the equipment to become live.<br />
Operation of the terminal is restricted to qualified personnel.<br />
The terminal has been designed for stationary installation.<br />
Place the terminal on a stable base during installation. The terminal may be<br />
damaged if it is dropped.<br />
Install the terminal according to the accompanying installation instructions.<br />
The unit must be grounded according to t he accompanying installation instructions.<br />
The installation must be perf ormed by qualified personnel.<br />
Route high-voltage cables, signal cables and supply cables separately from one<br />
another.<br />
Make sure that the voltage and polarity of the electrical power source are correct<br />
before you connect the terminal to the power supply.<br />
The openings in the housing are designed to allow air to circulate and must not be<br />
covered over.<br />
Do not install the terminal in locations w here it will be exposed to a powerful magnetic<br />
field.<br />
Do not install or operate the terminal where it will be exposed to direct sunlight.<br />
The peripheral equipment must be suitable for the application.<br />
On certain terminal models, the display glass is covered with a laminated foil to<br />
protect it from scratches. Pull off the foil carefully following installation to prevent static<br />
electricity causing damage to the terminal.<br />
2<br />
7
Change language