Operator Terminal System Manual - 11276916.pdf

I
Programming
7 Programming with the programming software
0
Programming
blocks
Double-click the required block in the block manager. The double-click opens the work
area for the block and the toolbox. The work area shows the graphic block or text block
manager depending on whether you open a graphic block or a text block. The toolbox
contains all objects that can be created in the block.
To select an object, click on the object in the toolbox and move the cursor to the position
in the work area where you want to place the object. A mouse click activates the dialog
box for the selected object. Enter the parameters into the dialog and click [OK]. The
object now appears on the work area. Static text or graphics are displayed directly on
the work area.
General object parameters are described in chapter 7.1, section "Basics". Graphic and
text objects are explained in chapters 7.4 "Graphical display and control" and 7.5 "Textbased
display and control".
Figure 39: Programming blocks
10412AEN
80 System Manual – DOP11A Operator Terminals