particular specifications (road works) - CIDCO Maharashtra Ltd.

CIDCO OF MAHARASHTRA LTD
C.A.No.01/CIDCO/SE(KHR)/EE(KHR-I)/2010–11 Pg. No. 478
appliances and pass them through the pipes and shall if required,
throw in water and show that it passed freely through every portion
of the work. Brick, mortar and rubbish shall not be allowed to fall in
into the manholes or sewer lines while fixing or if allowed shall be
removed by the contractor at their own expense.
b) The contractors to clean and use existing pipes met with
The contractors are if and when required, to take up any existing
pipes that be met with a clean and prepare them for reuse for such
work they will be paid at the contact rates for excavation and filling,
such excavation will be measured 0.90 M wide for 225 mm to 450
mm pipes, 0.60 M wider for smaller pipes and only in case to the
depth of pipes bed. The filling consolidation etc., shall be done as
described for new rocks and under the same conditions in every
respect.
35.0 MEASUREMENT OF PIPES
a) All pipes be measured according to the works actually done by
them, and no allowances will be made for any waste in cutting to the
exact length required. An exception to this will be made only in the
case of short branches of 100 mm dia stoneware pipes, which be
treated in the manner hereafter described with regard to fittings.
The contractor shall be under obligation to use the pieces or part of
the pieces out of from 100 mm stoneware pipes, if it be deemed by
the Engineer practicable to do so and no further payment shall be
made for the same to the contractor. A socket attached to a straight
pipe will not be measured, but a spigot end of a straight pipe
whether such end be free for entering into a socket will be measured
to its full length. Pieces of cut pipe not used in the work will become