particular specifications (road works) - CIDCO Maharashtra Ltd.

CIDCO OF MAHARASHTRA LTD
C.A.No.01/CIDCO/SE(KHR)/EE(KHR-I)/2010–11 Pg. No. 566
2. At all construction joints in the beams, slabs and columns etc.
1.15.15 Measurements:
laitance and any other loose concrete shall be chipped off
immediately after striking the formwork. The chipped surface
shall then be thoroughly cleaned with a jet of water.
1. Where formwork is paid separately, measurements shall be of
the area of finally exposed surface requiring shuttering
including curves, angles, splays, metres, bevels, etc. for which
no special rate shall be allowed. The rates shall be inclusive of
all work connected with provision of formwork, its erection
and removal and treatment of the concrete surface
immediately after removal of the formwork.
2. No extra payment shall be made for holes to be made in
formwork for inserting electrical conduits, hooks for fans, for
plumbing work.
3. Where boxes or pockets are required to be formed in the
concrete, they will be paid for separately at the Contract Rates,
but in measuring the area of concrete surfaces shuttered, no
deduction will be made for openings upto 0.4m 2 . For voids
larger than 0.4m 2 the surface of formwork forming the voids
shall be paid at rates of formwork set out in the Schedule and
the area of voids deducted from the face area of shuttering.
4. No deductions shall be made from formwork of main beams
where the secondary beams intersects it. Formwork to
secondary beams shall be measured upto sides of the main
beams. No deduction shall be made from the formwork to
stanchion or column casings at intersections of beam.