34169621 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH

More documents

Recommendations

Info

Datum Setting 12 SPEC FCT Z PROBE Z (appears only briefly) ENT 0 ENT or Select the Z axis. “SET” lights. The ❘
Datum Setting with the KT Edge Finder The ND position display units provide the following probing functions: Edge Probing: Setting a workpiece edge as datum Center Probing: Setting a midpoint between two workpiece edges as datum The probing functions are accessible in the SPEC FCT mode of operation. Before using the edge finder you must enter the stylus diameter and length in parameters P25 and P26, respectively (see “Operating Parameters”). During all probing functions, the ND position display unit accounts for the entered dimensions. The Edge Probing and Center Probing functions are describe on the following pages. Datum Setting 13
Page 1 and 2: User’s Manual Position Display Un
Page 3 and 4: This manual is for the ND display u
Page 5 and 6: Datum setting The workpiece drawing
Page 7 and 8: Nominal position, actual position a
Page 9 and 10: Switch-On, Traversing the Reference
Page 11: SPEC FCT SPEC FCT or PROBING ENT PR
Page 15 and 16: X PROBE X (appears only briefly) 5
Page 17 and 18: PROBE MIDP. X ENT If required, sele
Page 19 and 20: Moving the Axes with Distance-To-Go
Page 21 and 22: Bolt Hole Circles and Bolt Circle S
Page 23 and 24: HOLE DEPTH 5 START SPEC FCT ENT ENT
Page 25 and 26: SPEC FCT LIN. HOLE ENT 1ST HOLE X 2
Page 27 and 28: Working with Scaling Factors Scalin
Page 29 and 30: Part II Installation and Specificat
Page 31 and 32: Connections on Rear Panel ID label
Page 33 and 34: Connecting the Encoders Your displa
Page 35 and 36: List of Operating Parameters P1 Uni
Page 37 and 38: P80 Function of the CL key Set to z
Page 39 and 40: Parameter settings for HEIDENHAIN l
Page 41 and 42: Multipoint Axis Error Compensation
Page 43 and 44: Deleting a compensation value table
Page 45 and 46: RS-232-C/V.24 (Option) In addition
Page 47 and 48: Measured value output when probing
Page 49 and 50: Measured value output over the cont
Page 51 and 52: Example of measured value output ov
Page 53 and 54: Dimensions in mm/inches Tilting bas

34169621 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH

Create successful ePaper yourself

Delete template?

Save as template?