Aprilia SR 50 servicemanual - Scootergrisen

PERIODIC MAINTENANCE
2.2.4. GEAR FLUID IE361 – C364
CAUTION Use only recommended oil, see (LUBRICANT
CHART).
• Ride several kilometers (miles) to warm up the engine
to operating temperature and then stop the engine.
Check
• Position the vehicle on firm and level ground.
• Position the vehicle on the center stand.
2 - 26
WARNING
Allow several minutes for the engine and
exhaust system to cool down.
• Unscrew and extract the plug/dipstick.
• Clean the part in contact with the oil with a clean cloth.
• Tighten the plug/dipstick fully into the filler opening.
• Extract the plug/dipstick again and check the oil level
on the dipstick.
• The correct level is achieved when the oil reaches
approximately the second mark over the dot.
• If necessary, top up.
TOPPING UP
• Pour a small quantity of oil into the filler opening. Allow
one minute for the oil to flow into the crankcase.
• Check the oil level and top up if necessary.
• Top up by adding small quantities of oil, until reaching
the prescribed level.
• When finished, tighten the plug/dipstick.
CAUTION Do not use the vehicle when lubricant levels are
low or the lubricant has become contaminated. Use
specified lubricants only. Improper lubrication will lead to
moving part fretting, resulting in irreparable damage.
SR 50