Aprilia Scarabeo 4T servicemanual - Scootergrisen
Aprilia Scarabeo 4T servicemanual - Scootergrisen
Aprilia Scarabeo 4T servicemanual - Scootergrisen
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MIXER OIL TANK<br />
Carefully read p. 2 (GENERAL SAFETY RULES).<br />
CAUTION<br />
Carefully wash your hands after handling the oil.<br />
Dispose of the oil properly.<br />
KEEP OIL AWAY FROM CHILDREN.<br />
WARNING<br />
If you should run the mixer oil tank dry, the engine<br />
will seize. This could cause an upset, or other accident,<br />
with subsequent serious injury or even death.<br />
CHECKING<br />
Carefully read above (MIXER OIL TANK).<br />
CHECKING THE MIXER OIL LEVEL GAUGE UNIT<br />
♦ Remove the saddle support, see p. 29 (REMOVING<br />
THE SADDLE SUPPORT).<br />
CAUTION<br />
Handle with care.<br />
Do not force tubes or cables.<br />
♦ Remove the mixer oil level gauge unit (1).<br />
♦ Verify the efficiency of the mixer oil level gauge unit<br />
(1), p. 95 (CHECKING THE MIXER OIL LEVEL<br />
SENSOR).<br />
CHECKING THE MIXER OIL FILTER<br />
♦ Empty the mixer oil tank completely, see below<br />
(DRAINING).<br />
♦ Check, and if necessary, wash the filter (2), and the<br />
filtering element with a fireproof solvent, removing all<br />
deposits and foreign matter.<br />
DRAINING<br />
Carefully read above (MIXER OIL TANK).<br />
♦ Remove the rear part of the fairing, see p. 22 (RE-<br />
MOVING THE REAR PART OF THE FAIRING).<br />
♦ Remove the tank cap (3).<br />
♦ Place a container of at least 2 l (2.11 US qt) capacity<br />
under the filter coupling to catch the oil.<br />
♦ Cut the hose clamp (4) which attaches the hose to the<br />
filter (2) and remove.<br />
NOTE Upon reassembly, this clamp will be replaced<br />
with a screwdriver type worm clamp of the appropriate<br />
size. This clamp may be obtained from local sources.<br />
♦ Disconnect the filter (2) from the mixer oil tank (5).<br />
CAUTION<br />
Position and tie the filter (2) vertically, so that the<br />
residual oil left in the tube (6) cannot flow out.<br />
♦ Put all the drained oil in an appropriate container, close<br />
it and store it in a safe place.<br />
5<br />
Release 00 2003-02<br />
4<br />
2<br />
<strong>Scarabeo</strong> 50 I.E.-50/100 <strong>4T</strong><br />
1<br />
6<br />
3<br />
35