DM-4800 OWNER'S MANUAL - zZounds.com - Tascam
DM-4800 OWNER'S MANUAL - zZounds.com - Tascam
DM-4800 OWNER'S MANUAL - zZounds.com - Tascam
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
“Fat channel”<br />
To the left of the display is an area containing a number<br />
of encoders and keys.<br />
These controls are dedicated to module functions,<br />
and are divided into three sections: dynamics, EQ,<br />
and Aux sends.<br />
When a channel module is selected, the appropriate<br />
screen can be shown, and the parameters adjusted<br />
using these controls.<br />
These controls also allow you to copy and paste settings<br />
between channels.<br />
Dynamics processors<br />
When a module with dynamics processing has been<br />
selected, press the SCREEN key as shown above to<br />
bring up the module’s dynamics screen.<br />
The gate and <strong>com</strong>pressor/expander can then be<br />
turned on and off using the GATE ON and COMP/<br />
EXP ON keys, respectively (these keys light when<br />
2 – Basic operational concepts : “Fat channel”<br />
Figure 2.20: Dynamics processor controls<br />
Other parameters (and protection against overwriting<br />
existing parameters) can be copied using the screen<br />
as described in“UTILITY copying” on page 30.<br />
Full details of EQ and dynamics processors are given<br />
in the section on Modules, but this section explains<br />
how to use these dedicated controls.<br />
NOTE<br />
Some modules do not have dynamics processors, or<br />
equalization, or aux sends (see “About the <strong>DM</strong>-<strong>4800</strong>”<br />
on page 11). These controls described here are, of<br />
course, only valid for modules for which the appropriate<br />
facilities are available.<br />
the appropriate processor for the selected module is<br />
active).<br />
Use the SELECT key to determine whether the<br />
encoders will affect gate (GATE) or <strong>com</strong>pressor/<br />
expander (COMP/EXPAND).<br />
These encoders work as follows:<br />
Gate Compressor/expander<br />
THRESH Threshold level THRESH Threshold level<br />
RANGE Range of gate RATIO Compression/expansion ratio<br />
ATTACK Attack time ATTACK Attack time<br />
HYST Hysteresis value RELSE Release time<br />
HOLD Gate hold time OUTPUT Output level (disabled if AUTO<br />
MAKEUP is on<br />
DECAY Decay time AUTO MAKEUP Auto level makeup switch (with<br />
indicator)<br />
Table 2.3: Dynamics processor control assignments<br />
TASCAM <strong>DM</strong>-<strong>4800</strong> User’s Manual 27