Philips Magic2 Kala GB Manual - Fax-Anleitung.de
Error You have switched on your answering machine and cannot receive any faxes. PAPER JAM DOCUMENT JAM INKFILM LOW The signal tone does not sound when the cordless handset is hung up on the base station. You cannot hear a dial tone on your cordless handset. You cannot hear a dial tone, although the cordless handset has been charging for more than 12 hours on the base station. Possible cause You use background music. Your outgoing message is too long. One sheet or more sheets of paper were not drawn in straight. One document was not drawn in straight or more documents were both drawn in at the same time. Your ink film is nearly used up. The charging contacts are not making contact. The charging contacts need cleaning. You have not connected the receiver part correctly to the fax machine. The battery of the cordless handset is empty. You are too far away from your fax machine The battery can no longer be recharged. 32 Remedy Record a message without music. Record a shorter announcement (no longer than 20 seconds). Open the operation panel and pull the paper carefully outwards from the inside. Remove the scanner and pull the paper carefully outwards in one direction. Get a new ink film. Pick up the cordless handset and hang up again. Clean the contacts with a dry cloth. Check the connections (see Installation chapter). Hang up the cordless handset on the base station and wait for at least 12 hours. Come closer to the fax machine. Please contact your PHILIPS dealer and obtain new batteries.
Service code ! Only use this function when absolutely necessary. If you are satisfied with your changes to the factory settings you should not use this function. Function 45 (Service code) is used to delete some or all of your changes to the factory settings. This function enables you to partially or fully reconfigure your device. It is especially helpful if you have modified settings but find that your fax machine does not respond as expected. After deleting some or all of your custom settings please rerun EASY INSTALL. The following codes are at your disposal: Code No. 7117 This will delete all the settings you have altered on the fax machine. Code No. 7140 If you enter this code all the settings and data you have entered in the fax machine will be deleted, apart from the following: your personal outgoing message on your built-in answering machine received messages stored short dial numbers stored telephone book numbers your name your telephone number Example for using a service code: 1 Select MENU 45 and press OK. Enter the service code (7117 or 7140). Press OK. 2 With you can select whether you really want to delete your settings. Confirm with OK. Your fax machine will be reset to its original configuration. 33 Störungen Logging on and off the base station If the s symbol on your cordless handset blinks after connection it is not logged on to the fax machine. In order to log it on, or if you wish to log on additional cordless handsets to the fax, you must again enter the code on the receiver of the fax machine in the cordless handset. Logging on 1 Unplug your fax from the mains and plug it back in again. 2 Press o and 4. 3 Enter the code of the cordless handset. The code is on the receiver on the paper holder. 4 Press o. Logging off You can log off one handset, if you have already connected four handsets or one handset is faulty. 1 Unplug your fax from the mains and plug it back in again. 2 Press o and 5. 3 Enter the code of the cordless handset. 4 Press o again. You can also log off all other handsets if you have connected more handsets to the base station in your fax machine: 1 Unplug your fax from the mains and plug it back in again. 2 Press o and 6. 3 Enter the code of the other cordless handset and confirm with o. If you also wish to use cordless handsets from other manufacturers, please refer to the instructions for use for this cordless handset.