om, rz3016, rz3016bf, 2009-09, zero turn consumer - Power ...

More documents

Recommendations

Info

operation Open the fuel valve. Open the fuel valve 8050-010 Press in and turn the ignition key to the start position STOP Turn to START position 8050-135 When the engine starts, immediately release the ignition key back to the run position. IMPORTANT INFORMATION Do not run the starter for more than 5 seconds each time. If the engine does not start, wait approximately 10 seconds before retrying. STOP 26 - HUSQVARNA Release ignition to the RUN position 8050-136
Slowly slide the choke control back to the middle position when the engine has started. Set the desired engine speed with the throttle. Allow the engine to run at a moderate speed, “half throttle” for 3-5 minutes before loading it to heavily. USE FULL THROTTLE WHEN MOWING (no choke). operation WARNING! Weak Battery Engine exhaust and certain vehicle components contain or emit chemicals considered to cause cancer, birth defects, or other reproductive system damage. The engine exhaust contains carbon monoxide, which is a odorless, colorless, poisonous gas. Do not use the machine in enclosed spaces. WARNING! Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries. Use full throttle when mowing IMPORTANT INFORMATION Your mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use your mower to start other vehicles. 8050-007 If your battery is too weak to start the engine, it should be recharged. (See “Battery” in the Maintenance Section.) If “jumper cables” are used for emergency starting, follow this procedure: Jumper cables • Connect each end of the RED cable to the POSITIVE (+) terminal on each battery, taking care not to short against chassis. • Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully charged battery. • Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery. To remove cables, reverse order • Remove BLACK cable first from chassis and then from the fully charged battery. • Remove RED cable last from both batteries. Jumper cable connection 8011-642 HUSQVARNA-27
Page 1 and 2: Operator Manual RZ3016 / 966042901
Page 3 and 4: Contents INTRODUCTION..............
Page 5 and 6: INTRODUCTION Congratulations Thank
Page 7 and 8: symbols and decals These symbols ar
Page 9 and 10: SAFETY WARNING! THIS CUTTING MACHIN
Page 11 and 12: SAFETY Personal Safety Equipment WA
Page 13 and 14: SAFETY WARNING! The engine must not
Page 15 and 16: • Sparking can occur when working
Page 17 and 18: CONTROLS This operator’s manual d
Page 19 and 20: Parking Brake The parking brake is
Page 21 and 22: Fuel Shut Off Valve The fuel shut o
Page 23 and 24: operation Read “Safety Instructio
Page 25: Move the steering controls outward
Page 29 and 30: Operating on Hills Read the Safety
Page 31 and 32: Stopping the Engine Allow the engin
Page 33 and 34: MAINTENANCE Maintenance Schedule Th
Page 35 and 36: MAINTENANCE Battery Your mower is e
Page 37 and 38: Engine Cooling Air Intake Check tha
Page 39 and 40: MAINTENANCE EZT Belt To replace EZT
Page 41 and 42: MAINTENANCE Caster Wheels Check eve
Page 43 and 44: Front Wheel Mount Lubricate with a
Page 45 and 46: TROUBLESHOOTING Problem Cause The e
Page 47 and 48: WIRING DIAGRAM 8050-050 Husqvarna -
Page 49 and 50: TECHNICAL DATA RZ3016 / 966042901 a
Page 51 and 52: CONForMITY CERTIFICATES USA require
Page 53 and 54: SERVICE JOURNAL Action Date, mtr re
Page 60: P/N 115 161426 R1 09/10/09

om, rz3016, rz3016bf, 2009-09, zero turn consumer - Power ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?