TURCO 6813 Thin.pdf

TURCO ® 6813 THIN
ENVIRONMENTALLY ADVANTAGED PAINT REMOVER FOR
IMMERSION APPLICATIONS
DESCRIPTION:
TURCO 6813 THIN is a light amber, diphase liquid developed for removing chemical resistant paints,
such as epoxies, polyurethanes, and epoxy primers, from aircraft alloys, by immersion methods.
FEATURES:
TURCO 6813 THIN offers these features:
1. Does not contain chlorinated solvents, phenols, chromates, or other heavy metals
2. Long tank life
3. Use as received - no mixing or dilution required
4. Operates at or near room temperature 15-50°C (60-120°F)
5. Flash point over 92°C (200°F), Pensky-Martens Method
6. Solution has low vapor emission
7. Oil seal reduces odor
8. Passes ASTM F519 Type 1A hydrogen embrittlement test
USE INSTRUCTIONS:
Equipment: Tanks and associated equipment should be fabricated from mild or stainless steel.
Stainless steel is preferred. Do not use tanks fabricated from thermoplastic materials, fiberglass or
tanks with plastic liners.
Application: Transfer TURCO 6813 THIN from container to tank. Immerse parts below seal until
paint is loosened. Operate tank from 15-50°C (60-120°F). Rinse with high pressure water. Dry parts
by any convenient method.
DISPOSAL INFORMATION:
Dispose of spent solution per local, state and regional regulations. Refer to your TURCO MATERIAL
SAFETY DATA SHEET for additional disposal information.
WARNING! Causes skin and eye irritation
TURCO 6813 THIN contains benzyl alcohol and ammonia. Avoid contact with eyes, skin and clothing.
Do not take internally. Use with adequate (equivalent to outdoor) ventilation.
1

Protective clothing, such as a chemical face shield or goggles and gloves, apron and boots, made
from solvent resistant materials should be worn when handling and using this product. Air purifying full
face respirators with ammonia cartridges should be worn if concentrations is above PEL.
Store in closed containers away from excessive heat or direct sunlight.
Before using this product refer to container label and TURCO MATERIAL SAFETY DATA SHEET for
additional precautionary, handling and first aid information.
NOTICE:
The above information and recommendations concerning this product are based upon our laboratory tests and field use
experience with this or similar products. However, since conditions of actual use are beyond our control, any recommendations
or suggestions are made without warranty, express or implied. Manufacturer's and seller's sole obligation shall be to replace
that portion of the product shown to be defective. Neither shall be liable for any loss, damage, or injury, direct or consequential,
arising out of the use of this product.
4/97
TDB #241
2