Tamarin marine paints ltd. - Tambour Paints
Tamarin marine paints ltd. - Tambour Paints
Tamarin marine paints ltd. - Tambour Paints
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Application Condition:<br />
Area should be clean and dry prior to application.<br />
Temperature should be above the dew point during application, avoiding condensation.<br />
The temperature of the surface and the paint must be above 7ºC.<br />
Maximum steel temperature 45ºC.<br />
Do not exceed 20-25 mic DFT (on smooth steel). Epitamarin Uniseal “G” should be<br />
applied in a uniform thickness. Air spray to be used by a low pressure, under constant<br />
circulation.<br />
As a sealer coat: dilute up to 10% with Thinner 4-100. If applied over zinc silicate, make<br />
sure that the zinc silicate is fully cured before application Epitamarin Uniseal “G”.<br />
Storage and Packing:<br />
Store in cool and well ventilated place. Container must be kept tightly closed.<br />
Packaging size: 20 Ltr.<br />
Remarks:<br />
This product will not cure adequately below 10ºC.<br />
Before recoating Epitamarin Uniseal “G”, after exposure in contaminated environment,<br />
area should be cleaned by high pressure fresh water. Area should be dry before<br />
application.<br />
The numerical information quoted in the data sheet is subject to normal manufacturing<br />
tolerances. Practical covering can vary depending on application conditions, structure and<br />
weather conditions. The volume solids figure is the percentage of dry film obtained from a<br />
given wet film thickness under specified application rate and conditions.<br />
The interval given assumes preparation consistent with good painting practice.<br />
Safety Precautions:<br />
Refer to P.P.A. 3/1. Before and during use observe all safety labels on packaging and<br />
paint containers. Consult <strong>Tamarin</strong> Material Safety Data Sheet. Avoid direct contact with<br />
skin and eyes. (Gloves, goggles, face mask, barrier cream, etc.) Provide adequate<br />
ventilation if product comes in contact with skin wash with warm water and soak. If eyes<br />
are contaminated flush with water for 10 minutes and obtain medical attention.<br />
Basic Safety Precautions:<br />
This product contains flammable materials. Keep away from sparks and open flames. No<br />
smoking should be permitted in the area. Observe all precautionary notices on containers.<br />
Additional safety information is available on request.<br />
The information in this data sheet is given in good faith and to the best of our knowledge.<br />
It is subject to revision from time to time, in light of experience and our policy of continues<br />
Product development. Since condition of application and service may be beyond our<br />
control, no liability can be accepted on basis of this data.<br />
61