Print Station Operator's Guide - Kodak

Chapter 2. Operator Controls
Status Screens
Figure 2.6
Printhead ready status screen
Print Station # 1
Remote Eyelid PRINTHEAD READY Time: complete
Press ESC to return to previous MENU State # 16
SYSTEM STATUS MEASUREMENTS MESSAGES
Fluid Servo ON 14.99 PSI
Vacuum Servo ON 10.0 In. Hg.
Printhead (S1000) 12345 Serial No.
Stim. Drive ON 0.299 Tab Vrms
Chg. Plt.Heater ON
Ready to Print
PntHd Ink/Amb. Temp. 29./27. Deg. C
Charge Voltage ON (130.7 Volts)
Ink Concentration OK
Ink Level OK
Off Line
Printhead Use 207.5 Hours Exit Save
Print Station Use 1234 Hours
Title Section
The title section (Figure 2.7) of the status screen identifies the following
information:
Eyelid Status
This area shows whether the print station or the data station has
control of the printhead eyelid. If the location displays Remote
Eyelid, the data station controls the eyelid as long as the print
station is ready. If the location displays Local, the print station
controls the eyelid.
Function Status
The name of the function appears in this area. When the function
name is flashing, it means the function is active, when the function
name is static (not flashing), it means the function has been
completed or is not running.
Time Remaining
This area displays a countdown (in seconds) of time remaining until
the function reaches its final state or is completed.
State Number
This area displays which state is active. All states are numbered. The
number changes to indicate the state.
Operator’s Guide 2 - 7