Views
4 years ago

Produktinfo E allgemein 700 & 900 - KS Paul GmbH

Produktinfo E allgemein 700 & 900 - KS Paul GmbH

Produktinfo E allgemein 700 & 900 - KS Paul

PRODUCT - INFORMATION MOLY-PAUL 700 & 900 SERIES Sealing, Lubrication and Release of Refractory Products The MOLY-PAUL® 900 and 700 Product Series are fume-free and non toxic product ranges that are specially made for the "FLOW CONTROL" area of steel making. Their prime functions are to reduce the wear and extend the life of refractory parts. These high performance products are based upon naturally occurring minerals, synthetic and natural graphites, vegetable oils and water. Special additives are used as passive or active anti-oxidants. All of the products are harmless to the environment. MOLY-PAUL® 900 and 919 are pastes that can be applied by spatula, brush, roller or sponge. They can be used to finish both new and refurbished refractory plate surfaces. MOLY-PAUL® 942 FAV is a low-shrinking product that fills surface imperfections. MOLY-PAUL® 912 is a low friction emulsion that is applied in steel works. It is used on rotary sliding gate valve plates and the plates of linear furnace tap-hole gates to reduce wear and control friction. By design, MOLY-PAUL® 930 and 950 are available for use with atomising spray equipment such as hand-held spray guns and purpose built automatic systems. The products can be used on all types of refractory materials and in all working conditions. The General Information (page 4) identifies the products that contain anti-oxidants. The coatings are continuous bonded dry thin films that are smooth and give an oxidation and wear resistant surface. When dry they are primarily low friction neutral refractory materials. MOLY-PAUL® 715 is for the coating of continuous casting moulds. It is suitable for both "startercasting" and "link-casting" procedures. In the concentrated form is a pseudo-plastic suspension that on drying effectively prevents molten steel from adhering to the mould faces during initial casting procedures. The product is applied with a paint sponge or roller. The spray applied aqueous suspension MOLY-PAUL® 750 is specifically formulated for use on thin slab caster moulds. MOLY-PAUL® 783 is a highly specialised non-melt grease paste with a natural oil base fluid that forms a bonded dry high purity graphite film on exposure to heat in the caster mould. MOLY-PAUL® 959 and MOLY-PAUL®979 are mould release products for monolithic refractory formers and moulds. MOLY-PAUL® 979 is used for the release of heat cured dry-mix resin bonded materials. Both products are compatible with wooden, laminate, plastic, metal and composite mould formers. They can be used in conjunction with all commonly used refractory materials, bonding agents and fillers. Application is by atomising spray gun, paint brush, paint roller or a painting pad or sponge. FUCHS LUBRITECH GMBH Neuenhofstraße 101 - MOLY-PAUL DIVISION - 47055 Duisburg / Germany phone: +49 (0) 203 578861-0 fax: +49 (0) 203 57886120 e-mail: molypaul@fuchs-lubritech.de www.kspaul.de January 2013 Rev. 08 DIN ISO 9001 / EN 29001

DL 500 W - KS Paul GmbH
KSP 105 - KS Paul GmbH
MP-Carbaflo XTR5F-engl - KS Paul GmbH