EFM User Manual - CTC Union Technologies Co.,Ltd.

More documents

Recommendations

Info

3.4.3 LAN Press Next to set the next page: Enter Parameters in LAN: LAN type item can been selected as: Disable, Dynamic IP or Static IP. Selecting either Disable and Dynamic IP will 'grey out' all the Static IP settings. If you select Static IP, you can enter the following: IP, Subnet Mask, Gateway and DNS Server’s IP. You must type the dotted decimal notation for DNS Server’s IP address The default values are as following: IP Address: 192.168.2.1 Subnet Mask: 255.255.255.0 Gateway: 0.0.0.0 DNS Server 1: 168.95.1.1 DNS Server 2: 168.95.192.1 DNS Server 3: (Note: the above DNS server IP are for Hinet ISP in Taiwan. Please use your provider's DNS.) 26
3.4.4 Review Press Next to set the next page: The screen will display the new configured parameters. Double check the parameters and Click Restart The <strong>EFM</strong> modem will reboot and work with the new parameters or press <strong>Co</strong>ntinue to configure other parameters. 27
Page 1: G.SHDSL.bis EFM Network Extender
Page 4 and 5: Legal The information in this publi
Page 6 and 7: 3.5.2 VLAN.........................
Page 8 and 9: 4.10 ADMINISTRATION................
Page 10 and 11: 1.2 Features Extend Ether
Page 12 and 13: 1.4 Applications EFM DSLAM to point
Page 14 and 15: LED status of EFM Modem : LEDs Acti
Page 16 and 17: 2.2.2 LAN ports and MGMT port The E
Page 18 and 19: 3 Configuration use Web Browser 3.1
Page 20 and 21: 3.3 Setup up with Web Browser This
Page 22 and 23: The diagram below shows the basic s
Page 24 and 25: 3.4.2 DHCP server Press Next to set
Page 28 and 29: 3.5 Advanced Setup Note: The advanc
Page 30 and 31: 3.5.1.5 SNR margin SNR margin is an
Page 33 and 34: 3.5.2.1 802.1Q Tag-Based VLAN Click
Page 35 and 36: Before enabling VLANs for the EFM m
Page 37 and 38: The default setting is all ports co
Page 39 and 40: On devices of different vendors, th
Page 41 and 42: 3.5.3.1 Port Based Priority When yo
Page 43 and 44: 3.5.3.2 VLAN Tag Priority When you
Page 45 and 46: According to the previous two table
Page 47 and 48: The following is an illustration ab
Page 49 and 50: 3.5.4 Rate Control Click Rate Contr
Page 51 and 52: The below display screen is from a
Page 53 and 54: 3.6.3 LAN LAN status will display t
Page 55 and 56: 3.7 Administration This session int
Page 57 and 58: Legal address pool will setup the l
Page 59 and 60: 3.7.2.1 Community Pool To enable th
Page 61 and 62: 3.8 Utility This section will descr
Page 63 and 64: 3.8.2 Config Tool The configuration
Page 65 and 66: 3.8.4 Logout To exit the web config
Page 67 and 68: 4 Configuration use Serial Console
Page 69 and 70: The following figure gives you an e
Page 71 and 72: If you are the authorized user, you
Page 73 and 74: Command Description: Command enable
Page 75 and 76: 4.4.1.3 Annex There are two types o
Page 77 and 78:
4.4.3 VLAN Virtual LAN (VLAN) is de
Page 79 and 80:
Access Trunk The port can receive o
Page 81 and 82:
4.4.4.2 Queue weight This setting c
Page 83 and 84:
4.4.4.5 VLAN Tag Priority QoS -----
Page 85 and 86:
4.4.5 RATE Move the cursor " >> " t
Page 87 and 88:
To configure DHCP server, move the
Page 89 and 90:
4.4.9 Host name A Host Name is the
Page 91 and 92:
4.5.2 Interface Move cursor " >> "
Page 93 and 94:
4.9 Ping Ping command can use to di
Page 95 and 96:
Move the cursor ">>" to attrib and
Page 97 and 98:
4.10.3 SNMP Simple Network Manageme
Page 99 and 100:
SNMP Trap Host: Trap Host entry(1~5
Page 101 and 102:
4.11.1 Upgrade main software Move t
Page 103 and 104:
5 Appendix - Setup table SHDSL.bis:
Page 105 and 106:
QoS Mode: QoS Mode □Disable □Po
Page 107:
SNMP Community: SNMP entry (1) Vali
show all

EFM User Manual - CTC Union Technologies Co.,Ltd.

Create successful ePaper yourself

Delete template?

Save as template?