Download - Uddeholm

RIGOR
ELMAX
VANADIS 4
EXTRA
VANADIS 10
A through hardening steel recommended for very long
production runs of smaller complicated moulding.
Powder metallurgically produced mould steel characterized
by very good dimension stability, good polishability
and wear resistance. Uddeholm Elmax is corrosion
resistant, Uddeholm Vanadis 4 Extra has the highest
toughness and Uddeholm Vanadis 10 the best wear
resistance. Recommended for long production runs of
smaller and complicated shapes and/or abrasive plastics.
VANCRON 40 Uddeholm Vancron 40 is a good alternative to surface
coating in order to reduce galling, sticking and adhesive
wear and reduce friction. It also has a high polishability.
HOLDAX
ROYALLOY 1)
RAMAX HH
ALUMEC 89
A pre-hardened holder steel, supplied at 290–330 HB, with
a very good machinability.
A pre-hardened corrosion resistant holder steel, with
good machinability, high tensile strength and excellent
weldability.
Pre-hardened corrosion resistant holder steel, supplied at
320–352 HB and can be used for dies and calibers for
plastic extrusion as well as for holders/bolsters.
High strength Al-alloy supplied at ~160 HB. Recommended
for blow moulds, prototype moulds and for short
runs with low demands on strength and wear resistance.
MOLDMAX HH High strength Beryllium-Copper alloy, supplied at 40 HRC.
MOLDMAX XL High strength Nickel-Tin-Copper alloy supplied at ~30 HRC.
2)
The different Moldmax alloys are suitable mould materials
for a variety of moulding situations where a combination
of high thermal conductivity, corrosion resistance and
good polishability are needed.
1)
Uddeholm RoyAlloy is produced and patented by Edro Specially Steels, USA.
2)
Moldmax is a trade mark registered by Materion Brush Performance Alloys, Ohio.
For more detailed recommendations, see the application brochure “Steel for Moulds” or
the product information brochure available for each steel grade.
34