Warrior Skills Level 1 - Leader Development for Army Professionals

Performance Steps
b. Remove the rail grabber (standard or insight).
(1) Loosen the clamping knob.
(2) Remove the rail grabber.
(3) Retighten the knob.
c. Remove the alternate M16 mounting bracket (mounted around the front
sight).
(1) Loosen the knob.
(2) Remove the mount.
(3) Retighten the knob.
(4) Remove the M16A1 barrel adapter (M16A1 only).
5. Inspect the aiming light and components.
a. Inspect, by sight, the equipment for completeness, obvious damage, a
readable data plate, or missing parts.
b. Record deficiencies.
c. Report any deficiencies to unit maintenance, if applicable.
6. Stow aiming light and accessories.
a. Ensure the batteries are removed.
b. Ensure that the aiming light is in the OFF position.
c. Place aiming light and components into carrying bag or carrying case.
d. Secure the carrying bag (or carrying case).
Evaluation Preparation: Setup: Provide the Soldier with the equipment
and/or materials described in the conditions statement.
Brief Soldier: Tell the Soldier what is expected by reviewing the task
standards. Stress the importance of observing all cautions, warnings, and
dangers to avoid injury to personnel and, if applicable, damage to
equipment.
Performance Measures GO NO GO
1. Ensured weapon was cleared. —— ——
2. Removed (if installed) the remote switch and cable —— ——
hangers.
3. Removed the aiming light from the mount. —— ——
4. Removed the AN/PAQ-4 mount from the weapon. —— ——
5. Inspected the aiming light and components. —— ——
6. Stowed aiming light and accessories. —— ——
Evaluation Guidance: Refer to chapter 1, paragraph 1-9e, (1) and (2).
STP 21-1-SMCT 2 May 2011 3-21