3 years ago

IC36240 User's Manual - Asante

IC36240 User's Manual - Asante

You can add comments to

You can add comments to a configuration file describing the commands you have entered. Precede a comment with an exclamation point (!). Use the following commands to configure the software from the terminal. Command configure Switch(config)# copy running-config startup-config end or press Ctrl-Z (^Z) Purpose Enters global configuration mode and select the terminal option. The global configuration prompt. Enter the necessary configuration commands. Saves the configuration file to your startup configuration. On most platforms, this step saves the configuration to NVRAM. Exits global configuration mode. In the following example, the hostname command is used to change the hostname from "Switch" to "new_name". By pressing Ctrl-Z (^Z) or entering the end command, you quit 1 the global configuration mode. Finally, the copy running-config startup-config command saves the current configuration to the startup configuration. Switch# configure Switch(config)# hostname new_name new_name(config)# end new_name# copy running-config startup-config When the startup configuration is in NVRAM, it stores the current configuration information in text format as configuration commands, recording only non-default settings. The memory is checksummed to guard against corrupted data. 5.2.2 Copying Configuration Files to a Network Server You can copy configuration files from the switch to a file server using TFTP. You might wish to back up a current configuration file to a server before changing its contents, thereby allowing you to later restore the original configuration file from the server. Important: TFTP is not a secure protocol. Your server IP address and configuration file name will not be protected over the public Internet. Use TFTP only on a trusted LAN connection. To specify that the running or startup configuration file be stored on a TFTP network server, use the following commands in the EXEC mode. (Note: Copying the startup configuration file to the current running configuration merges the two files. You should keep a copy of the start-up configuration file before merging the two in case you want to revert to the original startup configuration). 40 Asante IntraCore IC36240 User’s Manual

The following is an example of copying the startup-config for use on the switch. Switch# copy startup-config ? running-config Update (merge with) current system configuration tftp:[//A.B.C.D/filename] Copy to tftp: file system 41 Asante IntraCore IC36240 User’s Manual

EFM User Manual - CTC Union Technologies Co.,Ltd.
EAP350 User Manual - EnGenius Technologies
User's Manual for FH316 Dual Speed hub - Asante
FMUX01A/Plus User Manual - Products
FMUX01A/Plus User Manual -
EOe1-A User Manual - Products
PHB-200 User Manual - CTC Union Technologies Co.,Ltd.
Rovio User manual - WowWee
ECB600 User Manual - EnGenius Europe
User Manual [ver 4.00] - KOUKAAM, a.s.
Download User Manual -
AirLive WN-5000R User's Manual
Download User Manual -