3 years ago

IC36240 User's Manual - Asante

IC36240 User's Manual - Asante

• Select the ports on

• Select the ports on each bridge that forward traffic, and place the redundant ports in blocking states To change the global STP status, select the desired state from the drop down menu. Use this screen to change the bridge priority, hello time maximum age, forward delay by entering the desired time in the text boxes and pressing Apply Changes. The allowed ranges are next to each text box. To restore the defaults press the restore button. The defaults are: Bridge Priority: 32768 Bridge Hello Time: Bridge Maximum Age: Bridge Forward Delay: 2 seconds 20 seconds 15 seconds Using multiple spanning trees allow VLAN groups to maintain a stable path between all VLAN members. This reduces the overall amount of protocol traffic crossing the network and provides a shorter reconfiguration time if any link in the spanning tree fails. 9.5 SNMP Configuration SNMP allows network managers to obtain specific performance and configuration information from a software agent on a remote-network device. SNMP allows different types of networks to communicate by exchanging network information through messages known as protocol data units (PDUs). The IntraCore IC36240 supports SNMPv1, v2 and v3. The SNMPv3 protocol has improved the authentication, access control, and security methods 84 Asante IntraCore IC36240 User’s Manual

Use this screen to set the read/write access and to enable or disable the trap authentication for this switch. The default SNMP read community access is public; the default SNMP write community access is private; the default trap authentication is disable. You can also set SNMP Traps for specific IP addresses allowing them to have access to communities that is different then the default set for the switch. To access the SNMP Configuration screen click on the SNMP button on the left side of the screen. The following example shows assigning an IP address to a specific community. 1. Type public in the SMNP Read Community text box; public indicates anyone on the network has read access to your network 2. Type private in the SNMP Write Community text box; private means that access is restricted 3. Select Enable from the Trap Authentication drop down menu; select enable to allow the switch to authenticate access 4. Type in the IP address and Community address; SNMP addresses to be trapped 5. Click on Apply Changes 85 Asante IntraCore IC36240 User’s Manual

EFM User Manual - CTC Union Technologies Co.,Ltd.
User's Manual for FH316 Dual Speed hub - Asante
EAP350 User Manual - EnGenius Technologies
FB-100A Series User's Manual - Kamery IP
FMUX01A/Plus User Manual -
FMUX01A/Plus User Manual - Products
SHDTU03 TDM NTU Series User Manual
User Manual - Busse Yachtshop