Views
3 years ago

IC36240 User's Manual - Asante

IC36240 User's Manual - Asante

The following screen

The following screen shows the output from selecting Port 1. The Address table at the bottom of the screen filtered out all the ports except port 1. The MAC address of the switch is identified as “self”. To sort the Address Table by IP address, click the Sort by IP button. The table is now sorted numerically by IP address. The MAC Address Table is a table of node addresses that the switch automatically builds by “learning.” It performs this task by monitoring the packets that pass through the switch, checking the source and destination addresses, and then recording the source address information in the table. 88 Asante IntraCore IC36240 User’s Manual

To sort the Address Table by MAC address, click the Sort by MAC button. Your table will be sorted numerically by MAC address. 9.7 VLAN Configuration VLANs are used to organize any group of network nodes into separate broadcast domains. VLANs confine broadcast traffic to the originating group and eliminate broadcast storms in large networks. VLANs provide a secure and efficient network environment. VLANs are based on untagged port groups, or traffic can be explicitly tagged to identify the VLAN group to which it belongs. Untagged VLANs can be used for small networks attached to a single switch. Tagged VLANs should be used for larger networks, and all the VLANs assigned to the inter-switch links. A VLAN is a group of end stations with a common set of requirements, independent of physical location. VLANs have the same attributes as a physical LAN but allow you to group end stations even if they are not located physically on the same LAN segment. VLANs are usually associated with IP subnetworks. For example, all the end stations in a particular IP subnet belong to the same VLAN. Traffic between VLANs is assigned. LAN port VLAN membership is assigned manually on an port-by-port basis. VLANs can be defined as either Layer 2 or Layer 3 and a VLAN cannot switch between the two layers. Before you create a VLAN, you must decide how they will be created and a naming convention to ensure duplicate VLAN names are not used. Up to 4094 Virtual LANs (VLANs) are supported on the IntraCore IC36240. The default VLAN with VLAN ID (VID) 1. All switchports (eth1–eth24) are included in the default VID 1. The default VID 1 cannot be deleted. Use this screen to view VLAN information and create a VLAN group. At the top of the main VLAN screen you can toggle between VLAN group information and VLAN port information by click on each link. 89 Asante IntraCore IC36240 User’s Manual

EFM User Manual - CTC Union Technologies Co.,Ltd.
EAP350 User Manual - EnGenius Technologies
User's Manual for FH316 Dual Speed hub - Asante
FMUX01A/Plus User Manual - Products
FMUX01A/Plus User Manual - Datainterfaces.com
PHB-200 User Manual - CTC Union Technologies Co.,Ltd.
Rovio User manual - WowWee
EOe1-A User Manual - Products
ECB600 User Manual - EnGenius Europe
User Manual [ver 4.00] - KOUKAAM, a.s.
Download User Manual - Y3k.com