h-cmd4001.pdf - Hyundai Electronics
Caution: Do not interchange the connection of the wiring!!! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized car dealer before installing this unit. Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit. 3. Cut the connector, connect the colored leads of the power cord to the car battery as shown in the color code table below for speaker and power cable connections. Location Function Connector A Connector B 1 Rear Right(+)---Purple 2 Tel-mute (gray) Rear Right(-)---Purple/Black Stripe 3 Front Right(+)---Grey 4 Battery 12V (+)/yellow Front Right(-)---Grey/Black Stripe 5 Auto Antenna/blue Front Left(+)---White 6 Front Left((-)---White/Black Stripe 7 ACC+/red Rear Left(+)---Green 8 Ground/black Rear Left(-)---Green/Black Stripe 8
Parking wire Note: The parking wire is connected with brake signal; for safety, the programs can be seen on the monitor after braking the car. (brown) Connecting the reversing line to taillight on the car After connecting, when you start up the reverse gear, the unit will receive the picture from car rear view camera. 9
EJECT , . SD/MMC , , RESET. . OP
SEL, : BASS ( ) => TRELE ( ) => BAL
10 , . «» (DUAL) DUAL KEY VOL
DUAL ---, DVD RADIO . MENU,
- 2 1~6, . : - (). - 1~6. RP
REG AF/REG 2 , REG. - REG ON ().
FAT 32 ( 200 , 500 ). : 32 / : 32 .
, : 2, 4, 8, 16, 32. PLAY/PAUSE,
2. PLAY/ PAUSE «PLAY»
WMA (Windows Media Audio) - , M
 : , DVD-, . , , . : .  : ,
 : ENTER, . , «STEREO».
1. 2.G . 3.PG 4.PG-13 5.PG-R 6.R 7
, : PAL=>SECAM1=> SECAM2; OK .
1. . 2. , . 3. . , ().
. . , “”. . . , . . .
: : (A-vtd): DSP : : 30 - 18