GL900 USER'S MANUAL - Graphtec

Settings and Measurement
3.4 Setting Menus
When you press the MENU key during Free Running, the following menu screens appear.
The menu screens are classified by the tab for each setting item.
(1) AMP settings
This menu is used to specify input signal-related settings.
Setting
Selections available
Input
Off, Voltage, Temperature, Humidity
Range [Voltage] 20, 50, 100, 200, 500 mV; 1, 2, 5, 10, 20,50,100,200,500V,1-5V
[Temperature]
TC-K, TC-J, TC-T, TC-R, TC-E, TC-B, TC-S, TC-N, TC-W
Filter
Off, Line, 5, 50, 500Hz
EU Function Off, On
(Scaling Measured Upper limit value Numeric value input
settings) value Lower limit value Numeric value input
EU output Upper limit value Numeric value input
value Lower limit value Numeric value input
Decimal point 1, 10, 100, 1000, 10000
Unit selection
Current, length, area, volume, speed, acceleration, frequency,
weight, power, pressure, flow, temperature
Unit
(Selections vary depending on the selected units listed in the above.)
User-defined unitText input
Misc. Span Upper limit value Numeric value input
setting Lower limit value Numeric value input
Annotation setting
Text input (31 characters max.)
Waveform color setting
Red/Green/Blue (RGB) 0 to 31 available for each color
Perform Auto Zero ADJ.
Execute
Reset Auto Zero ADJ.
Execute
Logic and Pulse
Off, Logic, Pulse
[Logic]
Off, On
[Pulse] Input Off, Revolution counts, Counts, Inst.
Filter
Off, On
Slope
↑ H, ↓ L
EU Function Off, On
Measured value Numeric value input
EU output value Numeric value input
Unit selection Current, length, area, volume, speed, acceleration, frequency,
weight, power, pressure, flow, temperature
Unit
(Selections vary depending on the selected units listed in the above.)
User-defined unit Text input
3-17