Views
3 years ago

Akai MPC-60 v2.0 Owners Manual.pdf - Fdiskc

Akai MPC-60 v2.0 Owners Manual.pdf - Fdiskc

146 Sending a Midi

146 Sending a Midi sample dump to an external sampler To send a Midi sample dump to an external sampler, press the SOUNDS key, then type 6, then press SOFT KEY 2, , and the following screen will appear: This is the "Send sample dump" screen. The screen fields and soft keys are described below: • The MIDI INPUT, MIDI OUTPUT, and FORMAT fields: These fields operate exactly as in the "receive" screen, described in the previous section. • The SEND CHANNEL field: When the sample dump is sent from the MPC60, it is sent over the midi channel specified in this field. For this reason, it is important to set this field to the same channel as the external sampler's midi receive channel. NOTE: When an incoming "dump request" message is received, this field is automatically changed to the channel of the dump request message, and the dump is sent out on that channel. • The SELECT SOUND TO section: The two fields in this section are only used if the send is initiated by pressing the soft key- if the send is initiated by an externally generated "dump request" message, the external sampler determines which sound will be sent. The DRUM field is used to select the sound to be sent. As you change the DRUM field, the NAME field changes to show the sound currently loaded into that drum. Also, to the right of the contents of the DRUM field is a number, used to indicate the internal sample number of the selected sound. When initiating the transfer from the external sampler, use these fields to view the number of the sound you wish to externally instruct the MPC60 to send. • SOFT KEY 1- : After the on-screen fields have been set as desired, pressing this soft key will cause the MPC60 to start sending the sample dump. At this point, the lower two lines of the screen will change to:

Section 6: Sampling and editing sounds 147 The transfer may take as long as a few minutes. When finished, the previous screen status will be re-displayed. If a transmission error occurs, or if the sample dump is cancelled by the other sampler, the dump will be cancelled and the previous screen will be re-displayed. If you wish to cancel the sample dump, press the soft key. NOTE: It is not necessary to press to initiate the outgoing midi sample dump. If the MPC60 receives a "dump request" message from the external sampler at any time, it will immediately display the "Sending midi sample dump" message and begin sending the requested sound to the external sampler. (The DRUM field will immediately change to display the requested drum.) Further, if a sample dump is received while the "Receive midi sample dump" screen is showing (described in the previous section), the screen will immediately change to the "Send midi sample dump" screen and begin sending the data. Also, the MPC60 responds to incoming "dump request" messages on all channels- it doesn't matter what channel the incoming message is sent on. • SOFT KEY 2 - : Pressing this soft key causes the "Receive midi sample dump" screen to be displayed, described in the previous section. Pressing it again returns to the "Send" screen.

DD-65/YDD-60 Owner's Manual - zzounds.com
Tandy Model 3 Disk System Owners Manual.pdf - 400 Bad Request
OWNER'S MANUAL - Roland
Roland KC-60 Owners Manual - Sweetwater.com
Roland KC-60 Owners Manual - Sweetwater.com
Akai MPC-3000 v3.0 Owners Manual.pdf - Fdiskc
Alesis Micron Owners Manual.pdf - Fdiskc
Akai MPC Catalog - MIDI Mark
Akai MPC2500 Manual - Platinum Audiolab
Setting up the MPK49 and MPD32 with Ableton Live - Akai
Owners Manual.pdf - Decware
EL DIABLO 60 Owners Manual - Genz Benz
MPC60 Users Manual Updated for v3.10 - Roger Linn Design