Views
3 years ago

Akai MPC-60 v2.0 Owners Manual.pdf - Fdiskc

Akai MPC-60 v2.0 Owners Manual.pdf - Fdiskc

92 The on-screen fields

92 The on-screen fields are: • The FROM BAR, field: This is the 1st bar to be deleted. • The TO BAR field: This field specifies the end of the region to be deleted (the bar number following the last bar to be deleted). For example, to delete bars 3 and 4, you would enter a 3 in the FROM BAR field and a 5 in the TO BAR field, because bar 5 is the end of the region to be deleted. This field cannot accept a value less than that of the FROM BAR, field. • SOFT KEY 1- : Pressing this soft key performs the above specified deletion. NOTE: If the sequence is set to loop to an earlier bar (in the time signature / ending status screen) and the deleted bars are before the loop point, causing the sequence to now loop to a different place, the bar number specified in the LOOP field will be automatically changed to compensate for the insertion. 4.3.5 Copying a section, including al! tracks, and inserting it elsewhere This function allows you to copy a specified range of bars from one sequence and insert it into any other point within the same sequence or any other sequence. In this form of the copy function, all tracks are copied, and this data is inserted into the new location. In this mode of copying, the overall length of the sequence will always be increased by the copy. To use this function, select option 5 from the EDIT screen, and the following screen will appear:

Section 4:Editing sequences 93 The on-screen fields are described below: • The SEQUENCE field (in the COPY ALL TRACKS FROM section): This field is used to specify the sequence number to be copied from. • The FROM BAR and TO BAR fields: These fields set the range of bars to be copied from. FROM BAR sets the 1st bar which is to be copied, and TO BAR sets the end of the region to be copied (the bar number following the last bar to be copied). • The SEQUENCE field (in the COPY ALL TRACKS TO section): This field is used to specify the sequence number to be copied to. • The COPIES field: This field specifies the number of copies of the specified data will be inserted into the insertion point. Normally, this would be set to 1. • The INSERT BEFORE BAR field: This field specifies the bar number which the copied data will be inserted before. To insert the bars after the end of the sequence, enter here the number of the bar which is one higher than the last bar of the sequence. • SOFT KEY 1- : Pressing this soft key performs the copy according to the entered parameters. NOTE: If the sequence is set to loop to an earlier bar (in the time signature / ending status screen) and the copied bars are inserted before the loop bar, causing the sequence to now loop to a different bar, the bar number specified in the LOOP field will automatically be adjusted to compensate for the insertion. 4.3.6 Copying a single track to another area or merging it with other data This function permits the copying of all events within a specified region on a single track to a different point on the same or another

DD-65/YDD-60 Owner's Manual - zzounds.com
Roland KC-60 Owners Manual - Sweetwater.com
Roland KC-60 Owners Manual - Sweetwater.com
OWNER'S MANUAL - Roland
Tandy Model 3 Disk System Owners Manual.pdf - 400 Bad Request
Akai MPC-3000 v3.0 Owners Manual.pdf - Fdiskc
Alesis Micron Owners Manual.pdf - Fdiskc
Akai MPC Catalog - MIDI Mark
Akai MPC2500 Manual - Platinum Audiolab
Setting up the MPK49 and MPD32 with Ableton Live - Akai
Owners Manual.pdf - Decware
EL DIABLO 60 Owners Manual - Genz Benz