Panel Descriptions Rear Panel and Bottom Panel (HP503) MIDI Connectors You can connect these to external MIDI devices. Input Jacks If a digital audio player or other audio playback device is connected here, you’ll be able to listen to its playback through the HP503. Use the controls of your audio playback device to adjust the volume. DC In Jack Connect the page 62 included AC adaptor here. * Before making this connection, you must make sure that the [Power] switch is off. Pedal Connector Connect the pedal page 62 cord of the dedicated stand to this connector. Rear side Output Jacks If you connect these jacks to amplified speakers, the sound of HP503 will be heard through them. Phones Jacks Here you can connect stereo headphones. The HP503 has two headphone jacks, two people can also use headphones simultaneously. Don’t forget to remove your headphone adaptor plug! If you leave a headphone adaptor plug inserted in the headphone jack, no sound will be heard from the piano. If you don’t hear sound from the piano, check the headphone jacks. 12 * To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections. * When connection cables with resistors are used, the volume level of equipment connected to the Input jacks may be low. If this happens, use connection cables that do not contain resistors.
&& Before You Play * When opening/closing the lid or raising/folding down the music rest, please be careful not to get your fingers pinched between the movable part and the panel. In places where small children are present, make sure that an adult provides supervision and guidance. Setting Up the Music Rest (HP505) 2. 2. Raising the music rest 2. 1. 1. Gently raise the music rest. 2. Fold down the latches to secure the music rest. Folding down the music rest 1. While using one hand to support the music rest, raise the latches located on the back of the music rest, then gently fold down the music rest. Setting Up the Music Rest (HP503) Attach the included music rest using the procedure described below. Attaching the music rest 1. Insert the included music rest attachment screws into the screw holes on top of the HP503, and tighten the screws slightly. 2. Put the music rest between the screws and the HP503’s body. Using the music holders You can use the holders to hold pages in place. When not using the holders, leave them folded down. Push 3. While supporting the music rest with one hand, secure it in place by turning the screws. Removing the music rest 1. Support it with one hand while loosening the screws. After removing the music rest, don’t forget to retighten the screws. NOTE Do not apply excessive force to the installed music rest. Be sure to use the supplied screws for attaching the music rest. Before moving the piano, be sure to remove the music rest to prevent accidents. Be careful not to lose the screws used to fasten the music rest, or allow small children to accidentally swallow them. Using the music holders You can use the holders to hold pages in place. When not using the holders, leave them folded down. Push Operation Guide Panel Descriptions Before You Play Performing Practicing Convenient Functions Function Mode Appendix When attaching the music rest, securely insert it all the way in, supporting it with your hand to make sure that you don’t drop it. Be careful, so you don’t get your fingers pinched. 13