Owner's Manual (HP-505_HP-503_OM.pdf) - Roland

rolandcorp.com.au

Owner's Manual (HP-505_HP-503_OM.pdf) - Roland

Various Settings (Function Mode)

Indication Value Explanation

Changing How the Pedals Work (Center Pedal)

CPdl Fnc

LocalCtl

When you turn on the power, the center pedal functions as the sostenuto pedal (p. 10).

You can change the function of the pedal to a variety of other operations.

SOST

Sets function to sostenuto pedal.

PLAY The pedal will have the same function as the [ ] (Play/Stop) button.

Pressing the pedal will layer on Tone 2, used for Dual play.

LAYR

* The Layer function can be applied only when using Dual play.

Pressing the pedal will layer on a sound one octave higher.

OCT

* The Octave function cannot be applied while using Twin Piano, Dual play, or Split play.

Preventing Doubled Notes When Connected to a Sequencer

(Local Control)

When you have a MIDI sequencer connected, set this parameter to Local Off.

Since most sequencers have their Thru function turned on, notes you play on the

keyboard may be sounded in duplicate, or get dropped. To prevent this, you can

enable the “Local Off” setting so that the keyboard and internal sound generator will be

disconnected.

Local Control

Sound Generator

MIDI

In

MIDI

Out

MIDI

Sequencer

OFF

Local Control is off.

The keyboard and composer are disconnected from the internal sound generator. Playing the keyboard will not produce sound.

ON

Local Control is on.

The keyboard and composer are connected to the internal sound generator.

MIDI Transmit Channel Settings (MIDI Transmit Channel)

MIDI Ch

This setting specifies the MIDI channel on which the unit will transmit.

MIDI uses sixteen “MIDI channels,” which are numbered 1 through 16. By connecting MIDI

devices and specifying the appropriate MIDI channel for each device, you can play or select

sounds on those devices.

The unit will receive all sixteen channels (1–16).

How to save your settings

Save your settings as described in “Memory

Backup” (p. 41).

OFF, 1–16

Setting the Type of CD To be Played Back (CD/Audio Type)

CD/A Typ

The unit may be unable to correctly recognize the type of CD being used. In such instances, you can specify the type of CD manually.

When the unit left the factory, this was set to “STRO” (Stereo). Normally, there is no need to make this setting.

MEMO

This setting is automatically saved in the unit.

AUTO, A, B, STRO

48

More magazines by this user
Similar magazines