ER-A220 Operation-Manual GB - Sharp

Programming EURO system settings
For details of EURO system settings, please refer to “PROGRAMMING FOR EURO”.
Printing exchange total amount and change amount on receipt or journal
Total and change amounts in exchange currency are printed respectively below each of the total and exchange
amounts in domestic currency.
Cheque and credit operation when tendering in foreign currency
Exchange calculation method
“Division” or “Multiplication” can be selected for the conversion method from domestic currency to exchange
currency, and the calculation is performed as follows:
In case that “Division” is selected:
Domestic currency amount Exchange rate = Exchange amount
In case that “Multiplication” is selected
Domestic currency amount Exchange rate = Exchange amount
To set “0” for all items
Ñ 8 ≈ Ñ É
*ABCD
* Item: Selection: Entry:
A Printing exchange total amount and Yes 1
change amount on receipt or journal No 0
B Always enter 0. 0
C Cheque and credit operation when Yes 1
tendering in foreign currency No 0
D Exchange calculation method Division 1
Multiplication 0
Key operation example
Print
Ñ 8 ≈
1000 Ñ
É
Programming power saving mode
For the details of power saving mode, please refer to “Power saving mode” of “PRIOR TO ENTRIES”.
To set “0” for all items
Ñ 10 ≈ Ñ É
*ABCD
* Item: Selection: Entry:
A Entering power saving mode Yes 0
when time is displayed No 1
B-D Time(min.) to entering power saving mode 001-254 or 999*
since no operation is made
* 999: inhibit entering power saving mode
Key operation example
Print
Ñ 10 ≈
0060 Ñ
É
24