Prestige 964 Cable Router Operator's Guide - bei GGA Maur

Prestige 964 Cable Router
6.1.7 remote_manage
This command is used to enable or disable remote access to the Prestige web interface through port 8080.
Example:
remote_manage true
6.1.8 tac_enable [ true | false ]
This command is used to enable or disable the TACACS authentication process.
Example:
tacacs_enable true
6.1.9 tac_ip [TACACS SourceIpType ]
This command is used to set the source IP address for TACACS packets.
Example:
tac_ip 1 Cable modem IP
tac_ip 2 Static IP
tac_ip 3 Wan IP
6.1.10 tac_server [ Primary TACACS Server ] [ Secondary TACACS Server ]
This command setup TACACS servers. The primary server is necessary and the secondary is optional.
Example:
tac_server 192.168.80.102 192.168.80.103
6.1.11 tac_md5 [ true | false ]
This command is used to enable or disable the TACACS authentication process with MD5 encryption.
Example:
tac_md5 true
6.1.12 tac_key [ TACACS Keystring ]
This command is used to set the TACACS MD5 key string. Of cause it is only needed when MD5 encryption is used.
Example:
tac_key mykey
6.2 Router Operation command
6.2.1 router_enable [ true | false ]
Enables/disables the route mode. If enabled, the P964CR operates in router mode, otherwise bridge mode.
Example:
router_enable true
router_enable false
6.2.2 ip_sharing [ true | false ]
Enable/disable IP sharing mode. If disabled, the P964CR will not assign IP address for it WAN interface. This value will be true
when “router_enable” is setting true. For Time Warner static IP services, this must be set to false.
Example:
ip_sharing true
6.2.3 static_ip [ IpAddress ] [ NetMask ]
Setup the static IP and netmask. It is used for setting a public IP subnet on P964CR
Example:
static_ip 203.211.2.1 255.255.255.0
6.2.4 static_ip2 [ IpAddress ] [ NetMask ]
Setup the second static IP and netmask. It is used for setting the second public IP subnet on P964CR
6-2 Command Sets