Prestige 964 Cable Router Operator's Guide - bei GGA Maur

Prestige 964 Cable Router
No: P964 support up to 10 entries from 1 to 10.
IP: An IP address at LAN side.
Protocol: 1 for TCP, 2 for UDP, and 3 for Both
Example:
CM> pfwd_enable 1 192.168.10.2 25 25 1
Must save and reboot to take effect!
6.2.15 pfwd_disable [No]
This command disables the above setting.
Example:
CM> pfwd_disable 1
Must save and reboot to take effect!
6.2.16 pfwd_show
This command shows the port forwarding table.
Example:
CM> pfwd_show
6.2.17 pflt_enable [No] [Start Port] [End Port] [Protocol]
This command set specified ports that can not be access from LAN CPEs. For example, the administrator does not want CPEs users
telnet to Internet. The port 23 for TCP can be filtered.
No: P964 support up to 10 entries from 1 to 10.
Port: 0 to 65535
Protocol: 1 for TCP, 2 for UDP, and 3 for Both
Example:
CM> pflt_enable 1 23 23 1
Must save and reboot to take effect!
6.2.18 pflt_disable [No]
This command disables the above setting.
Example:
CM> pflt_disable 1
Must save and reboot to take effect!
6.2.19 pflt_show
This command shows the port filtering table.
Example:
CM> pflt_show
6.3 LAN and DHCP Setting
6.3.1 dhcp_enable [ true | false ]
This command is to enable or disable the LAN DHCP service.
Example:
dhcp_enable true
6.3.2 dhcp_server [ DhcpServer ] [ NetMask ]
Set LAN DHCP server IP address and its net mask. It is also the LAN IP address. It can be set even when DHCP server is disabled.
Example:
dhcp_server 192.168.0.1 255.255.255.0
6.3.3 dhcp_pool [ DhcpStartAddress ] [ IpSize ]
Set LAN DHCP IP range starting from [DhcpStartAddress]. The pool size is [IpSize]
IpSize: IpSize number, range between 1..65535.
6-4 Command Sets