Icosit - TEKKON

Technical data
Material consumption:
Mixing ratio in parts
by weight:
(Components A : B)
Specific
gravity
liquid
approx.
kg/L
Solids content
approx. %
Theoretical film thickness
with 100 g/m 2 consumption
Material-consumption for
medium dry film thickness
of
by vol. by weight wet microns dry microns microns approx.
kg/m²
1,5 100 100 67 67 450 0,670
Max. film thickness of 750 microns per operation
77 : 23
Resistance: Chemicals:
Icosit TW 1 is resistant to water and waste water, neutral salts and disinfectants.
Not resistant to solvents and fuels.
Hints on application
Preparation of
material:
Temperature:
Dry heat up to approx. + 100°C,
Damp heat and warm water up to approx. + 40°C.
Stir Component A very thoroughly using an electric stirrer. Add component B and mix both
components very thoroughly for at least 3 minutes by means of an electric stirrer (including
sides and bottom of the container). Fill mixed material into a clean container and mix again.
Mixed material must have a uniform colour.
Important: DO NOT THIN !
Application method: The method of application has a major effect on achieving uniform thickness and appearance.
Spray application will give the best results. The indicated dry film thickness is easily
achieved by airless spray and by brush. Adding solvents reduces the sag resistance and the
dry film thickness. In case of application by roller or brush, additional applications may become
necessary to achieve the required coating thickness, depending on type of construction,
site conditions, colour shade etc. Prior to major coating operations a test application on
site may be useful to ensure the selected application method will provide the requested results.
Application
temperature:
(material and surface)
Airless-spray:
Efficient airless equipment. Gun pressure min. 200 bar; bore of nozzle 0,48 – 0,58 mm
(0,019 – 0,023 inch), spray angle 40° – 60°; diameter of hoses min. 8 mm (⅜ inch).
The use of an inline heater is necessary. The use of flow heater is necessary.
Brush or roller:
Because of short pot life we recommend the use of our smaller (3 kg) units for applications
by brush and roller.
surface: min. +15°C
material: min. +15°C
Potlife: at 20°C approx. 25 minutes
at 30°C approx. 15 minutes
at 40°C approx. 10 minutes
Important: When potlife is exceeded, material remnants react under
the development of heat and foaming and can flow over
the pail rim. Do not close lid firmly on pails
containing mixed material !
Icosit TW 1 2