Views
3 years ago

INDUCTION MODULE ASSEMBLY 9.5 - harley-davidson-sweden.se

INDUCTION MODULE ASSEMBLY 9.5 - harley-davidson-sweden.se

INDUCTION MODULE ASSEMBLY 9.5 -

HOME INDUCTION MODULE ASSEMBLY 9.5 GENERAL See Figure 9-23. The Induction Module Assembly consists of the following components: ● ● ● ● ● ● ● ● Induction Module Fuel Supply Line Fuel Rail/Fuel Supply Tube Fuel Injectors Intake Air Temperature Sensor Throttle Position Sensor Manifold Absolute Pressure Sensor Idle Air Control INDUCTION MODULE REMOVAL 1. Partially remove fuel tank. See Section 9.4 FUEL TANK (FUEL INJECTED), PARTIAL REMOVAL, either FLHT/ C/U/I, FLTRI or FLHR/C/S/I. 2. Remove air cleaner and backplate. See Section 4.5 AIR CLEANER, REMOVAL. 3. Pull purge tube from fitting at top of induction module (California models only). See Figure 9-23. 4. Using a needle nose pliers, carefully pull idle cable barrel from upper hole in throttle wheel. Pull throttle cable barrel from lower hole. Using slots, release idle and throttle cables from guides in throttle cable bracket. 5. On cruise control equipped models, remove E-clip from sleeve at end of cruise cable housing. Using slot, remove cable housing from cable guide in throttle cable bracket. Push the plastic end fitting on the cruise cable to the outboard side to release from wheel pin. See Figure 9-24. 6. Remove idle air control and manifold absolute pressure sensor connectors. Pull external latch(es) outward and use rocking motion to separate pin and socket halves. 7. Depress wire form to remove electrical connectors from front and rear fuel injectors. 8. Remove throttle position sensor and intake air temperature sensor connectors. 1. Fuel Injector (Front) 2. Throttle Cable Bracket 3. Idle Air Control 4. Throttle Position Sensor 5. Purge Tube Fitting (California Models Only) 6. Intake Air Temperature Sensor 7. Manifold Absolute Pressure Sensor 8. Fuel Injector (Rear) 9. Fuel Rail 10 10. Fuel Supply Tube 1 Front 2 3 9 7 f2162x9x 8 Rear 6 5 4 Figure 9-23. Induction Module Assembly 2004 Touring: Fuel Injection 9-27

DTC P0106, P0107, P0108 4.13 - harley-davidson-sweden.se
5.5 initial diagnostic check: efi - harley-davidson-sweden.se
4.4 initial diagnostic check: icm - harley-davidson-sweden.se
VariReg Throttle Position Sensor (TPS) Setting for Harley-Davidsons
cruise control (flhrc, fltr, flhtcu) 8.30 - Harley-Davidson-Sweden