WAUKESHA Manuale Inglese UNIVERSAL 1 - Asco Pompe Srl
WAUKESHA Manuale Inglese UNIVERSAL 1 - Asco Pompe Srl
WAUKESHA Manuale Inglese UNIVERSAL 1 - Asco Pompe Srl
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6. Grease front and rear bearing through grease fittings until grease is<br />
visible around roller assemblies.<br />
7. Secure shaft assemblies in housing with bearing retainers.<br />
Shim Here if Required<br />
See Note<br />
8. Check back face clearance. See Section 10,Table 1 and BACK FACE<br />
CLEARANCE.<br />
Retainer<br />
NOTE: Retainer must bottom out against bearing and leave .015 -<br />
.040" clearance with housing. Use shims between bearing and<br />
retainer if required.<br />
Gear Spacer<br />
Spacer Seal<br />
Rear Seal Assembly<br />
1. Install spacer seals and gear spacers.<br />
2. Coat lip of seals with ISO GradeNLGI grade 2 grease<br />
Seal (Lip Up)<br />
3. Press in rear seals with lip facing out.<br />
NOTE: On Model 60, 130 and 320 pumps rear seal is pressed in<br />
flush with housing. On Model 220 pumps the rear seal must not be<br />
flush. It must be 1/8 inch outside of housing.<br />
Section 9 - Assembly Procedures January 2006<br />
Page 42 95-03002
Change language