Bearing Puller Tool Instruction - Novatec
Bearing Puller Tool Instruction - Novatec
Bearing Puller Tool Instruction - Novatec
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
INSTRUCTION<br />
B E A R I N G P U L L E R T O O L<br />
Removing bearing from Dynamite and Demon front wheel.<br />
It is valid also for DH61SB and DH41SB hubs.<br />
Similar procedure for other hubs.<br />
2. May 2012
Page 2/5<br />
Step 1<br />
Prepare all necessary tools.<br />
Step 2<br />
<strong>Tool</strong> for removing side cap.<br />
We use alloy 20mm thru axle<br />
as a tool.<br />
Different side cap can require<br />
different tools.<br />
Step 3<br />
Insert alloy tube into side cap.<br />
Step 4<br />
Lever out side cap.
Page 3/5<br />
Step 5<br />
Choose proper size of bearing<br />
remover tool.<br />
In our case Ø 20mm.<br />
Bolt<br />
Extender<br />
Step 6<br />
Screw out bolt of extender<br />
to allow to squeeze extender.<br />
Step 7<br />
Squeeze the extender by fingers.<br />
Step 8<br />
Insert the extender through<br />
the bearing.
Page 4/5<br />
Step 9<br />
Screw in extender bolt in order<br />
to expand the extender.<br />
Step 10<br />
Screw in extractor lever<br />
to extender bolt.<br />
Step 11<br />
Hold wheel still.<br />
Pull up handle.<br />
Step 12<br />
Release bearing from hub body<br />
by extractor.
Page 5/5<br />
Step 13<br />
Screw out extractor lever<br />
from extender bolt.<br />
Step 14<br />
Screw out extender bolt<br />
from the extender.<br />
Step 15<br />
Squeeze the extender by fingers.<br />
Step 16<br />
Remove bearing from extender.